Recent breakthroughs in surface micromachining led to development of the first generation surface micromachined microfluidic devices. The simplest microfluidic device is a microfluidic channel (microchannel). A typical surface micromachined microchannel is about 2 pm deep, its width and depth depend on the specific application, while its top is less than 1 pm thick silicon nitride membrane. Almost all microfluidic devices are concerned with flow through very small passages and unintentional restrictions that lead to high-pressure gradients within the microchannels, which, in turn, cause deformations of the membranes. Knowledge of these deformations facilitates design and optimization of the microfluidic devices. We have developed a hybrid approach for accurate and precise characterization of microfluidic devices. This approach is based on Analytical, Computational, and Experimental Solutions (ACES) methodology. The experimental aspects of this methodology are based on laser interferometric measurements yielding displacement/deformation fields, while analytical and computational aspects are based on exact (closed form) and approximate (FEM) solutions, respectively. Comparison of analytical, computational, and experimental results indicates correlation to within 1%, for maximum deformations on the order of 1 μm. Continued advances in the methodology for characterization of the microfluidic devices will lead to development of robust devices, which will allow their integration with electronic actuation to enable a broad range of revolutionary new applications achievable with surface micromachining.
[1]
Ernest J. Garcia,et al.
Surface micromachined microengine
,
1995
.
[2]
S. Shoji.
Micro Total Analysis Systems
,
1999
.
[3]
Ryszard J. Pryputniewicz,et al.
Hybrid computational and experimental approach for the study and optimization of mechanical components
,
1998
.
[4]
Samuel Lee Miller,et al.
Surface Micromachine Microfluidics: Design, Fabrication, Packaging, and Characterization
,
1999,
Micro-Electro-Mechanical Systems (MEMS).
[5]
Masahiro Fujii,et al.
A low power, small, electrostatically-driven commercial inkjet head
,
1998,
Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.
[6]
Ryszard J. Pryputniewicz,et al.
New test methodology for static and dynamic shape measurements of microelectromechanical systems
,
2000
.
[7]
Ryszard J. Pryputniewicz,et al.
Absolute shape measurements using high-resolution optoelectronic holography methods
,
2000
.
[8]
A. Berg,et al.
Micro Total Analysis Systems
,
1995
.