High-energy density miniature thermoelectric generator using catalytic combustion

This paper describes the components and system of a thermoelectric (TE) generator with a catalytic butane combustor. The combustion chamber with a size of 8 mm/spl times/8 mm/spl times/0.4 mm is etched in a 0.65-mm-thick silicon substrate, and bonded to both sides of a 0.77-mm-thick glass substrate with a thin-film ignition heater. A set of 34 couples of BiTe TE elements, each with a size of 0.65 mm/spl times/0.65 mm/spl times/2 mm, are directly bonded to both sides of the combustor. The combustor without the TE modules was tested using butane as fuel, and self-sustaining combustion and electrical ignition were achieved. Also, nearly 100% combustion efficiency and a uniform temperature distribution were confirmed by gas chromatography and infrared thermoimaging, respectively. When the TE modules were attached to the combustor, however, butane combustion was impossible. The characteristics of TE generation were measured using hydrogen as fuel. When a theoretical combustion power was 6.6 W, the maximum output power of 184 mW was obtained with a load of 5.68 /spl Omega/. The total efficiency in this experiment was 2.8% (184 mW/6.6 W).

[1]  D. Rowe.  CRC Handbook of Thermoelectrics , 1995 .

[2]  Alan F. Jankowski,et al.  Novel proton exchange membrane thin-film fuel cell for microscale energy conversion , 2000 .

[3]  K. Jensen,et al.  A Combustion-Based MEMS Thermoelectric Power Generator , 2001 .

[4]  Khalil Najafi,et al.  An Integrated Combustor-Thermoelectric Micro Power Generator , 2001 .

[5]  M. A. Ryan,et al.  Where there is heat, there is a way: Thermal to electric power conversion using thermoelectric microconverters , 2002 .

[6]  W. Smyrl,et al.  Miniature fuel cells fabricated on silicon substrates , 2002 .

[7]  Suk Won Cha,et al.  Design and fabrication of a micro fuel cell array with “flip-flop” interconnection , 2002 .

[8]  Y. Kubo,et al.  Small Direct Methanol Fuel Cell Pack for Portable Applications , 2002 .

[9]  M. Esashi,et al.  MEMS-Based Polymer Electrolyte Fuel Cell , 2002 .

[10]  C. Shu,et al.  Development of microthermophotovoltaic system , 2002 .

[11]  Evan O. Jones,et al.  Microfuel processor for use in a miniature power supply , 2002 .

[12]  Jeremy P. Meyers,et al.  Design considerations for miniaturized PEM fuel cells , 2002 .

[13]  Chunbo Zhang,et al.  Micro combustion-thermionic power generation: feasibility, design and initial results , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[14]  Dominiek Reynaerts,et al.  Development of an axial microturbine for a portable gas turbine generator , 2003 .

[15]  K. Jensen,et al.  A thermophotovoltaic micro-generator for portable power applications , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[16]  Jesse S. Wainright,et al.  Microfabricated fuel cells , 2003 .

[17]  Jingrong Yu,et al.  Fabrication of miniature silicon wafer fuel cells with improved performance , 2003 .

[18]  Klavs F. Jensen,et al.  A microfabricated suspended-tube chemical reactor for thermally efficient fuel processing , 2003 .

[19]  Jenn-Kun Kuo,et al.  A Novel Design and Microfabrication for a Micro PEMFC , 2003 .

[20]  M. Esashi,et al.  Silicon-based micro-polymer electrolyte fuel cells , 2003, The Sixteenth Annual International Conference on Micro Electro Mechanical Systems, 2003. MEMS-03 Kyoto. IEEE.

[21]  Alan H. Epstein,et al.  Millimeter-Scale, MEMS Gas Turbine Engines , 2003 .

[22]  Masayoshi Esashi,et al.  A24-042 DEVELOPMENT OF MICROMACHINE GAS TURBINE FOR PORTABLE POWER GENERATION , 2003 .

[23]  Masayoshi Esashi,et al.  MEMS-Based Fuel Reformer with Suspended Membrane Structure , 2003 .

[24]  Fritz B. Prinz,et al.  Micro-Scale Radial-Flow Compressor Impeller Made of Silicon Nitride: Manufacturing and Performance , 2003 .

[25]  Masayoshi Esashi,et al.  Turbo test rig with hydroinertia air bearings for a palmtop gas turbine , 2004 .

[26]  M. Kothare,et al.  A microreactor for hydrogen production in micro fuel cell applications , 2004, Journal of Microelectromechanical Systems.

[27]  Masayoshi Esashi,et al.  MEMS-based components of a miniature fuel cell/fuel reformer system , 2004 .

[28]  Masayoshi Esashi,et al.  Micro Turbocharger on a Single Silicon Rotor , 2004 .

[29]  Young Ho Seo,et al.  MEMS-based direct methanol fuel cells and their stacks using a common electrolyte sandwiched by reinforced microcolumn electrodes , 2004, 17th IEEE International Conference on Micro Electro Mechanical Systems. Maastricht MEMS 2004 Technical Digest.

[30]  Masayoshi Esashi,et al.  Micro-ejector to supply fuel-air mixture to a micro-combustor , 2005 .

[31]  M. Esashi,et al.  Fabrication of novel MEMS-based polymer electrolyte fuel cell architectures with catalytic electrodes supported on porous SiO2 , 2006 .