MWCNT-conducting polymer composite based ammonia gas sensors: A new approach for complete recovery process

Abstract Highly sensitive ammonia gas sensors were fabricated using Multi-walled Carbon Nanotubes (MWCNTs) reinforced electrically conducting polymer composites following solution casting method. Two types of conducting polymers like poly(3,4-ethylenedioxythiophene)–polystyrene sulfonic acid (PEDOT:PSS) and polyaniline (PANI) were used and compared for their ammonia gas sensing properties at room temperature (RT). Both the sensors were found to exhibit excellent sensitivity and poor recovery for ammonia gas at room temperature, but as compared to PANI, PEDOT:PSS polymer composite was found to be more sensitive (with sensitivity of ∼16%) with less response time (∼15 min). In addition, thermal behavior of both the composites was investigated in detail, where MWCNT–PEDOT:PSS composite showed significantly better thermal stability than MWCNT–PANI composite. Sensor recovery posed a great problem at room temperature and a new approach is proposed to get complete recovery, exclusively tested in polymer–CNT composite sensor, to lessen the heat dependence and improve the cycling behavior. A trial experiment is conducted in combination of heat and DC electric field to optimize the complete recovery of the MWCNT–PEDOT:PSS composite based sensor where the recovery time was reduced from 48 h to 20 min. It is believed that such stimulation process provides sufficient energy to desorb chemisorbed ammonia from CNT surface completely.

[1]  C. Pearson,et al.  The morphology and electrical conductivity of single-wall carbon nanotube thin films prepared by the Langmuir–Blodgett technique , 2010 .

[2]  M. C. Petty,et al.  Gas sensing for the 21st century: the case for organic thin films , 2001 .

[3]  Jinhuai Liu,et al.  Preparation of gold/polyaniline/multiwall carbon nanotube nanocomposites and application in ammonia gas detection , 2008 .

[4]  Vijay K. Varadan,et al.  A compact wireless gas sensor using a carbon nanotube/PMMA thin film chemiresistor , 2004 .

[5]  Tarikul Islam,et al.  Spectroscopic Investigation of Modified Single Wall Carbon Nanotube (SWCNT) , 2011 .

[6]  Bin Zhang,et al.  Preparation and characterization of gas-sensitive composites from multi-walled carbon nanotubes/polystyrene , 2005 .

[7]  Chien-Sheng Huang,et al.  Three-terminal CNTs gas sensor for N2 detection , 2005 .

[8]  Seung Yol Jeong,et al.  Enhanced Sensitivity of a Gas Sensor Incorporating Single‐Walled Carbon Nanotube–Polypyrrole Nanocomposites , 2004 .

[9]  Ting Zhang,et al.  Poly(m-aminobenzene sulfonic acid) functionalized single-walled carbon nanotubes based gas sensor , 2007 .

[10]  Jose Maria Kenny,et al.  Sensors for inorganic vapor detection based on carbon nanotubes and poly(o-anisidine) nanocomposite material , 2004 .

[11]  Liming Dai,et al.  Controlled Synthesis and Modification of Carbon Nanotubes and C60: Carbon Nanostructures for Advanced Polymeric Composite Materials , 2001 .

[12]  Vijay K. Varadan,et al.  Carbon nanotube/PMMA composite thin films for gas-sensing applications , 2003 .

[13]  V. Singh,et al.  MWCNT–polymer composites as highly sensitive and selective room temperature gas sensors , 2011, Nanotechnology.

[14]  V. C. Moore,et al.  Individually suspended single-walled carbon nanotubes in various surfactants , 2003 .

[15]  Nicola Marzari,et al.  Sensing mechanisms for carbon nanotube based NH3 gas detection. , 2009, Nano letters.

[16]  A Wisitsoraat,et al.  The effect of carbon nanotube dispersion on CO gas sensing characteristics of polyaniline gas sensor. , 2006, Journal of nanoscience and nanotechnology.

[17]  Amin Salehi-Khojin,et al.  Sensitivity of nanotube chemical sensors at the onset of Poole–Frenkel conduction , 2010 .

[18]  P. Bartlett,et al.  Conducting polymer gas sensors part I: fabrication and characterization , 1989 .

[19]  W. D. de Heer,et al.  Carbon Nanotubes--the Route Toward Applications , 2002, Science.

[20]  S. S. Samal,et al.  Carbon Nanotube Reinforced Ceramic Matrix Composites- A Review , 2008 .

[21]  Joseph G. Shapter,et al.  Measurement of functionalised carbon nanotube carboxylic acid groups using a simple chemical process , 2006 .

[22]  P. Ajayan,et al.  Aligned Carbon Nanotube Arrays Formed by Cutting a Polymer Resin—Nanotube Composite , 1994, Science.

[23]  M. Scarselli,et al.  Electronic and optoelectronic nano-devices based on carbon nanotubes , 2012, Journal of physics. Condensed matter : an Institute of Physics journal.

[24]  G. Seifert,et al.  A hydrogen storage mechanism in single-walled carbon nanotubes. , 2001, Journal of the American Chemical Society.

[25]  Jing Sun,et al.  Carbon nanotube-ceramic composites , 2006 .

[26]  Jose Maria Kenny,et al.  NO2 and CO gas adsorption on carbon nanotubes: Experiment and theory , 2003 .

[27]  Lynn Fuller,et al.  A chemical sensor for chloromethanes using a nanocomposite of multiwalled carbon nanotubes with poly(3-methylthiophene) , 2005 .

[28]  Qian Wang,et al.  Toward Large Arrays of Multiplex Functionalized Carbon Nanotube Sensors for Highly Sensitive and Selective Molecular Detection. , 2003, Nano letters.

[29]  G. Mahan,et al.  Reflection by defects in a tight-binding model of nanotubes , 1999 .

[30]  Jing Sun,et al.  Production of aqueous colloidal dispersions of carbon nanotubes. , 2003, Journal of colloid and interface science.

[31]  Yoonseok Yang,et al.  The application of carbon nanotube-polymer composite as gas sensing materials , 2004, Proceedings of IEEE Sensors, 2004..

[32]  Tsukasa Akasaka,et al.  Oxidation of multiwalled carbon nanotubes by nitric acid , 2005 .

[33]  Jinhuai Liu,et al.  Gas sensors for ammonia detection based on polyaniline-coated multi-wall carbon nanotubes , 2009 .

[34]  Jiri Janata,et al.  Conducting polymers in electronic chemical sensors , 2003, Nature materials.

[35]  K. Morokuma,et al.  Sensitivity of ammonia interaction with single-walled carbon nanotube bundles to the presence of defect sites and functionalities. , 2005, Journal of the American Chemical Society.

[36]  M. Monthioux,et al.  Sensitivity of single-wall carbon nanotubes to chemical processing: an electron microscopy investigation , 2001 .

[37]  K. Rajanna,et al.  Ethanol sensing using CuO/MWNT thin film , 2011 .

[38]  M. Meyyappan,et al.  Carbon Nanotube Sensors for Gas and Organic Vapor Detection , 2003 .

[39]  M. Petty,et al.  Electrical conductivity of single-wall carbon nanotube film deposited by electrostatic layer-by-layer assembly with the aid of polyelectrolytes , 2009 .

[40]  Ting Zhang,et al.  Electrochemically Functionalized Single‐Walled Carbon Nanotube Gas Sensor , 2006 .

[41]  E. Snow,et al.  Role of defects in single-walled carbon nanotube chemical sensors. , 2006, Nano letters.

[42]  B. Ju,et al.  Gas sensing properties of single-wall carbon nanotubes dispersed with dimethylformamide , 2008 .