Experimental study of vibrational energy harvesting using Electro-Active paper

This paper presents an estimation of power output produced by an Electro-Active Paper (EAPap) energy harvesting transducer under base vibration. EAPap is very thin cellulose piezoelectric film, which exhibits a direct piezoelectric effect, when subjected to stress. A 50×50 mm2 EAPap patch was bonded on a 100×50×1 mm3 aluminum cantilever structure. Energy harvesting tests were performed on the energy harvesting transducer, without and with a 2 grams proof mass near the tip of the cantilever beam. The voltage, current and power frequency response functions (FRFs) with respect to the base acceleration are identified and presented. The Voltage FRFs show a monotonic trend with increasing the load resistor from 100 kΩ to 1 MΩ, and the current FRFs also demonstrate monotonic dynamic behavior, but the trend is opposite to the voltage FRFs. In contrast to the voltage and current FRFs, the output power FRFs do not show a monotonic trend, exhibiting the maximum value of 150 μW/g2 at 75.1 Hz without the proof mass. The output power increases to 392 μW/g2 at 62.2 Hz when the proof mass is attached. This preliminary study indicates that EAPap is promising for energy harvesting transducers under vibration environment.

[1]  Daniel J. Inman,et al.  Issues in mathematical modeling of piezoelectric energy harvesters , 2008 .

[2]  Jaehwan Kim,et al.  Mechanical properties of cellulose electro-active paper under different environmental conditions , 2008 .

[3]  Paul K. Wright,et al.  A piezoelectric vibration based generator for wireless electronics , 2004 .

[4]  Jaehwan Kim,et al.  A review of piezoelectric energy harvesting based on vibration , 2011 .

[5]  Jaehwan Kim,et al.  Electro-mechanical behavior and direct piezoelectricity of cellulose electro-active paper , 2008 .

[6]  Song-Yul Choe,et al.  Modeling and analysis of a bimorph piezoelectric cantilever beam for voltage generation , 2007 .

[7]  Jan M. Rabaey,et al.  Improving power output for vibration-based energy scavengers , 2005, IEEE Pervasive Computing.

[8]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless remote power supply , 2002 .

[9]  Gerhard M. Sessler,et al.  Piezoelectricity in cellular electret films , 2000 .

[10]  Jaehwan Kim,et al.  Piezoelectricity of wet drawn cellulose electro-active paper , 2009 .

[11]  Sungryul Yun,et al.  Discovery of Cellulose as a Smart Material , 2006 .

[12]  Jan M. Rabaey,et al.  A study of low level vibrations as a power source for wireless sensor nodes , 2003, Comput. Commun..

[13]  D. Inman,et al.  On Mechanical Modeling of Cantilevered Piezoelectric Vibration Energy Harvesters , 2008 .

[14]  Jaehwan Kim,et al.  Vibration Sensor Characteristics of Piezoelectric Electro-active Paper , 2010 .

[15]  Daniel J. Inman,et al.  An experimentally validated bimorph cantilever model for piezoelectric energy harvesting from base excitations , 2009 .

[16]  Sungryul Yun,et al.  Cellulose Smart Material: Possibility and Challenges , 2008 .

[17]  Guilherme Andrade Marson,et al.  An efficient, one‐pot acylation of cellulose under homogeneous reaction conditions , 2000 .

[18]  Sungryul Yun,et al.  Effect of solvent mixture on properties and performance of electro-active paper made with regenerated cellulose , 2008 .

[19]  Daniel J. Inman,et al.  A Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters , 2008 .

[20]  Sungryul Yun,et al.  Electrically aligned cellulose film for electro-active paper and its piezoelectricity , 2009 .

[21]  Alper Erturk,et al.  Electromechanical Modeling of Piezoelectric Energy Harvesters , 2009 .

[22]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[23]  Yi-Chung Shu,et al.  Analysis of power output for piezoelectric energy harvesting systems , 2006 .

[24]  Sihong Zhao,et al.  Electroelastic modeling and experimental validations of piezoelectric energy harvesting from broadband random vibrations of cantilevered bimorphs , 2012 .

[25]  Daniel J. Inman,et al.  Estimation of Electric Charge Output for Piezoelectric Energy Harvesting , 2004 .