Heat flow to the workpiece from a TIG welding arc
暂无分享,去创建一个
Less than half of the heat generated in a TIG welding arc (typically 1600 W at 16 V, 100 A) is transferred to the workpiece (anode). Convection, conduction and radiation from the gas occur over the whole of the arc region, but they represent relatively minor contributions to the total heat balance. The principal anode heating and cooling mechanisms involve electron and space-charge effects at the surface. These electron effects are evident in the workfunction (typically 45 V) which is dominant, the electron thermal energy transfer (1 V) and the anode fall (2 V), and they are concentrated in the restricted anode current spot so they may be considered as a localized heat source. Evaporation is most intense from the anode spot region and carries away some heat. However, most of the vapour condenses on the cooler, outer regions of the anode surface covered by the arc. In this way, heat is redistributed and diffused over a wider area. Vaporization effects explain the differences between previous measurements with cooled copper anodes (in which 80% of the arc power is transferred to the metal) and ones with practical, molten-steel welds (less than 50% heat transfer).
[1] M. Uman,et al. Introduction to Plasma Physics , 1964 .
[2] O. H. Nestor. Heat Intensity and Current Density Distributions at the Anode of High Current, Inert Gas Arcs , 1962 .
[3] P. H. Richards,et al. The use of electrostatic probes to measure the temperature profiles of welding arcs , 1973 .
[4] H. Maecker,et al. Plasmaströmungen in Lichtbögen infolge eigenmagnetischer Kompression , 1955 .
[5] Jack Murielle Somerville,et al. The electric arc , 1959 .