Interactions between oxygen permeation and homogeneous-phase fuel conversion on the sweep side of an ion transport membrane

The interactions between oxygen permeation and homogeneous fuel oxidation reactions on the sweep side of an ion transport membrane (ITM) are examined using a comprehensive model, which couples the dependency of the oxygen permeation rate on the membrane surface conditions and detailed chemistry and transport in the vicinity of the membrane. We assume that the membrane surface is not catalytic to hydrocarbon or syngas oxidation. Results show that increasing the sweep gas inlet temperature and fuel concentration enhances oxygen permeation substantially. This is accomplished through promoting oxidation reactions (oxygen consumption) and the transport of the products and reaction heat towards the membrane, which lowers the oxygen concentration and increases the gas temperature near the membrane. Faster reactions at higher fuel concentration and higher inlet gas temperature support substantial fuel conversion and lead to a higher oxygen permeation flux without the contribution of surface catalytic activity. Beyond a certain maximum in the fuel concentration, extensive heat loss to the membrane (and feed side) reduces the oxidation kinetic rates and limits oxygen permeation as the reaction front reaches the membrane. The sweep gas flow rate and channel height have moderate impacts on oxygen permeation and fuel conversion due to the residence time requirements for the chemical reactions and the location of the reaction zone relative to the membrane surface.

[1]  X. Tan,et al.  Oxyfuel combustion using a catalytic ceramic membrane reactor , 2008 .

[2]  J. R. Scotti,et al.  Available From , 1973 .

[3]  William J. Thomson,et al.  Oxygen permeation rates through ion-conducting perovskite membranes , 1999 .

[4]  J. Caro,et al.  Influence of CO2 on the oxygen permeation performance of perovskite-type BaCoxFeyZrzO3−δ hollow fiber membranes , 2010 .

[5]  H. Bouwmeester,et al.  Chapter 10 Dense ceramic membranes for oxygen separation , 1996 .

[6]  X. Tan,et al.  Mixed Conducting Ceramics for Catalytic Membrane Processing , 2006 .

[7]  Jaka Sunarso,et al.  Mixed ionic-electronic conducting (MIEC) ceramic-based membranes for oxygen separation , 2008 .

[8]  Y. S. Lin,et al.  Analysis of oxygen permeation through dense ceramic membranes with chemical reactions of finite rate , 2009 .

[9]  J. Kuipers,et al.  Feasibility study of a novel membrane reactor for syngas production: Part 1: Experimental study of O2 permeation through perovskite membranes under reducing and non-reducing atmospheres , 2007 .

[10]  J. Kuipers,et al.  Feasibility study of a novel membrane reactor for syngas production: Part 2: Adiabatic reactor simulations , 2007 .

[11]  Olav Bolland,et al.  High-temperature membranes in power generation with CO2 capture , 2004 .

[12]  M. Bradford,et al.  CO2 Reforming of CH4 , 1999 .

[13]  P. Glarborg,et al.  Chemically Reacting Flow : Theory and Practice , 2003 .

[14]  Jerry Y. S. Lin,et al.  Oxygen permeation through oxygen ionic or mixed-conducting ceramic membranes with chemical reactions , 2004 .

[15]  A. Feldhoff,et al.  Influence of CO2 on the oxygen permeation performance and the microstructure of perovskite-type (Ba0.5Sr0.5)(Co0.8Fe0.2)O3−δ membranes , 2007 .

[16]  M. Baum,et al.  Analysis of wall heat fluxes, reaction mechanisms, and unburnt hydrocarbons during the head-on quenching of a laminar methane flame , 1997 .

[17]  A. Ghoniem,et al.  Laminar oxy-fuel diffusion flame supported by an oxygen-permeable-ion-transport membrane , 2012 .

[18]  Dieter Winkler,et al.  Development and testing of AZEP reactor components , 2007 .

[19]  On diffusion flame attachment near cold surfaces , 1999 .

[20]  Henricus J.M. Bouwmeester,et al.  Dense ceramic membranes for methane conversion , 2003 .

[21]  Xiaoyao Tan,et al.  Design of mixed conducting ceramic membranes/reactors for the partial oxidation of methane to syngas , 2009 .

[22]  Ahmed F. Ghoniem,et al.  Numerical simulation of ion transport membrane reactors: Oxygen permeation and transport and fuel conversion , 2012 .

[23]  H. Tsuji.  Counterflow diffusion flames , 1982 .

[24]  Ahmed F. Ghoniem,et al.  A novel ion transport membrane reactor for fundamental investigations of oxygen permeation and oxy-combustion under reactive flow conditions , 2013 .

[25]  G. Dixon-Lewis,et al.  Structure of laminar flames , 1991 .

[26]  Wanqin Jin,et al.  Experimental and simulation study on a catalyst packed tubular dense membrane reactor for partial oxidation of methane to syngas , 2000 .

[27]  Roger B. Poeppel,et al.  Dense ceramic membranes for partial oxidation of methane to syngas , 1995 .

[28]  Henricus J.M. Bouwmeester,et al.  Dense Ceramic Membranes for Oxygen Separation , 1997, The CRC Handbook of SOLID STATE Electrochemistry.

[29]  Zebao Rui,et al.  Simulation of methane conversion to syngas in a membrane reactor. Part II , 2008 .

[30]  Sze Zheng Yong,et al.  Oxy-fuel combustion of pulverized coal: Characterization, fundamentals, stabilization and CFD modeling , 2012 .

[31]  L. Cot,et al.  Fundamentals of inorganic membrane science and technology , 1996 .

[32]  Daniel Holmberg,et al.  Chapter 31 – Techno-Economic Evaluation of an Oxyfuel Power Plant Using Mixed Conducting Membranes , 2005 .

[33]  Jiuping Xu,et al.  Greenhouse Gas Control , 2014 .

[34]  Y. S. Lin,et al.  Simulation of methane conversion to syngas in a membrane reactor: Part I A model including product oxidation , 2008 .