Snow stability during rain

The mechanical response of snow packs to penetrating liquid water was observed over two winter seasons in the central Cascade Mountains, Washington, U.S.A. Following the onset of rain, three evolutionary regimes of snow behavior were identified: immediate avalanching, delayed avalanching, and return to stability. Immediate avalanching occurred within minutes to an hour after the onset of rain and the time of release could be predicted with an accuracy of less than an hour from meteorological forecasts of the transition from snow to rain. These avalanches usually slid on surfaces substantially deeper than the level to which water or associated thermal effects had penetrated. The mechanism by which alteration of a thin skin of surface snow can cause deep slab failure has not been identified, but several possibilities involving a redistribution of stress are discussed. Delayed avalanches released several hours after rain started. The delay varied, depending on the rate of increasing stress associated with the additional precipitation, and on the time taken for water to penetrate and weaken a potential sliding layer. It is difficult to define accurately the evolving distribution ofliquid water in snow which makes it difficult to predict accurately the time of avalanching. Depth profiles of the rate of snow settlement showed that a wave of increased strain rate propagated into the snow in response to penetrating water. This type of measurement could prove useful for predicting when snow stability is reaching a critical condition. Avalanche activity was rare after continuation of rain for 15 h or more. This return to stability occurred after drainage structures had evolved and penetrated the full depth of the snowpack. Established drain channels route water away from potential sliding surfaces and are also relatively strong structures within a snowpack.