Numerical investigation of the aerodynamics and wake structures of horizontal axis wind turbines by using nonlinear vortex lattice method

Abstract Wind turbines are emerging as one of the most promising and cost-effective renewable energy sources, due to their economical merits and technical maturity. It is important to accurately predict the aerodynamic performance of rotor blades for efficient design of wind turbine. Among the various numerical approaches, the vortex lattice method (VLM) is one of the most suitable models for wind turbine aerodynamics because the wind turbine mostly operates in the subsonic flow. However, it inherently cannot predict the nonlinear aerodynamic characteristics at a high angle of attack. In the current paper, a nonlinear vortex lattice method (NVLM) has been suggested to extend the existing VLM for handling the nonlinear stall and post-stall behaviors. This can be possible by finding a control point in the airfoil where the effective angle of attack is applied. This paper mainly discusses the development and validation of the NVLM for predicting the aerodynamic performances and the wake geometry against the measurements on the MEXICO rotor model. The comparison results show that the aerodynamic loads and tip vortex trajectories computed by NVLM are in significantly good agreement with the measured data. In addition, the complicated and unsteady wake structures are also analyzed using vortex particle method.

[1]  Soogab Lee,et al.  Numerical analysis on the aerodynamics of HAWTs using nonlinear vortex strength correction , 2010 .

[2]  R. Mukherjee,et al.  Poststall prediction of multiple-lifting-surface configurations using a decambering approach , 2004 .

[3]  Flávio D. Marques,et al.  Lift Prediction Including Stall, Using Vortex Lattice Method with Kirchhoff-Based Correction , 2017 .

[4]  Duck-Joo Lee,et al.  Numerical simulations of wake structure generated by rotating blades using a time marching, free vor , 1997 .

[5]  T. Lutz,et al.  Final Report of IEA Wind Task 29 Mexnext (Phase 3) , 2018 .

[6]  Ashok Gopalarathnamand,et al.  Use of Lift Superposition for Improved Computational Efficiency of Wing Post-Stall Prediction , 2008 .

[7]  Stefan Ivanell,et al.  Validation of the actuator line and disc techniques using the New MEXICO measurements , 2016 .

[8]  Ashok Gopalarathnam,et al.  Iteration schemes for rapid post‐stall aerodynamic prediction of wings using a decambering approach , 2014 .

[9]  J. Anderson,et al.  Numerical lifting line theory applied to drooped leading-edge wings below and above stall , 1980 .

[10]  Spyros G. Voutsinas,et al.  Enhancement of Free Vortex Filament Method for Aerodynamic Loads on Rotor Blades , 2014 .

[11]  Sandeep Gupta,et al.  Development of a Time-Accurate Viscous Lagrangian Vortex Wake Model for Wind Turbine Applications , 2006 .

[12]  Evan M. Gaertner,et al.  Modeling Dynamic Stall for a Free Vortex Wake Model , 2015 .

[13]  Christian Bak,et al.  Development of the Risø wind turbine airfoils , 2004 .

[14]  D. Owens.  Weissinger's model of the nonlinear lifting-line method for aircraft design , 1998 .

[15]  W. A. Timmer,et al.  Thick airfoils for HAWTs , 1992 .

[16]  Daniel Micallef,et al.  Final report of IEA Task 29, Mexnext (Phase 1): Analysis of Mexico wind tunnel measurements , 2012 .

[17]  J. Leishman,et al.  Performance Predictions Of NREL Phase VI Combined Experiment Rotor Using A Free-Vortex Wake Model , 2006 .

[18]  G. Schepers,et al.  CFD computations of the second round of MEXICO rotor measurements , 2016 .

[19]  F. Blondel,et al.  Validation and comparison of aerodynamic modelling approaches for wind turbines , 2016 .

[20]  W. A. Timmer,et al.  Summary of the Delft University Wind Turbine Dedicated Airfoils , 2003 .

[21]  M. Selig,et al.  A 3-D stall-delay model for horizontal axis wind turbine performance prediction , 1998 .

[22]  Earl P. N. Duque,et al.  Navier-Stokes and Comprehensive Analysis Performance Predictions of the NREL Phase VI Experiment , 2003 .