Damage Detection Through Modal Flexibility-Based Deflections: Application to a Full-Scale RC Shear Wall Building

[1]  Carlos E. Ventura,et al.  Output-only damage diagnosis for plan-symmetric buildings with asymmetric damage using modal flexibility-based deflections , 2020 .

[2]  Ho-Yeon Jung,et al.  Damage detection for beam-like structures using the normalized curvature of a uniform load surface , 2013 .

[3]  Guirong Yan,et al.  Damage localization in ambient vibration by constructing proportional flexibility matrix , 2003 .

[4]  Billie F. Spencer,et al.  Damage detection in ambient vibration using proportional flexibility matrix with incomplete measured DOFs , 2007 .

[5]  Pier Francesco Giordano,et al.  Response‐based time‐invariant methods for damage localization on a concrete bridge , 2020, Structural Concrete.

[6]  Carlo Rainieri,et al.  Automated output-only dynamic identification of civil engineering structures , 2010 .

[7]  David P. Thambiratnam,et al.  A new method for locating and quantifying damage in beams from static deflection changes , 2019, Engineering Structures.

[8]  Carlo Rainieri,et al.  Operational Modal Analysis of Civil Engineering Structures: An Introduction and Guide for Applications , 2014 .

[9]  Carlos E. Ventura,et al.  Introduction to Operational Modal Analysis: Brincker/Introduction to Operational Modal Analysis , 2015 .

[10]  A. K. Pandey,et al.  Damage Detection in Structures Using Changes in Flexibility , 1994 .

[11]  Hyung-Jo Jung,et al.  Damage-induced deflection approach for damage localization and quantification of shear buildings: validation on a full-scale shear building , 2012 .

[12]  Joel P. Conte,et al.  System Identification Study of a 7-Story Full-Scale Building Slice Tested on the UCSD-NEES Shake Table , 2011 .

[13]  Luca Landi,et al.  On the Use of Singular Vectors for the Flexibility-Based Damage Detection under the Assumption of Unknown Structural Masses , 2018 .

[14]  Mustafa Gul,et al.  Damage assessment using flexibility and flexibility-based curvature for structural health monitoring , 2008 .

[15]  Raimondo Betti,et al.  Output-only damage detection in buildings using proportional modal flexibility-based deflections in unknown mass scenarios , 2018, Engineering Structures.

[16]  Jer-Nan Juang,et al.  An eigensystem realization algorithm for modal parameter identification and model reduction. [control systems design for large space structures] , 1985 .

[17]  José I. Restrepo,et al.  Shake Table Response of Full Scale Reinforced Concrete Wall Building Slice (NEES-2006-0203) , 2017 .

[18]  A. Emin Aktan,et al.  Use of Modal Flexibility for Damage Detection and Condition Assessment: Case Studies and Demonstrations on Large Structures , 2006 .

[19]  Billie F. Spencer,et al.  Experimental Verification of the Flexibility-Based Damage Locating Vector Method , 2007 .

[20]  Ahmet E. Aktan,et al.  Application of Modal Flexibility and Its Derivatives in Structural Identification , 1998 .

[21]  Chung Bang Yun,et al.  Damage detection in beam-like structures using deflections obtained by modal flexibility matrices , 2008 .

[22]  Thomas G. Carne,et al.  The Natural Excitation Technique (NExT) for modal parameter extraction from operating wind turbines , 1993 .

[23]  Ki-Young Koo,et al.  Damage detection of shear buildings using deflections obtained by modal flexibility , 2010 .

[24]  Joel P. Conte,et al.  Damage identification study of a seven-story full-scale building slice tested on the UCSD-NEES shake table , 2010 .

[25]  Hyung-Jo Jung,et al.  Modal flexibility-based damage detection of cantilever beam-type structures using baseline modification , 2014 .