Resistive humidity sensitivity of arrayed multi-wall carbon nanotube nests grown on arrayed nanoporous silicon pillars

Abstract Arrayed multi-wall carbon nanotube (CNT) nests were grown on a silicon nanoporous pillar array (Si-NPA) by thermal chemical vapor deposition and the corresponding microstructure was characterized. The room-temperature resistive humidity sensing properties and the electrical conducting mechanism of the CNT/Si-NPA were studied by a standard four-probe method and a hot probe method, respectively. It was shown that with the relative humidity (RH) changing from 11 to 85%, a resistance device response over 362% was achieved, and the curve of the resistance response with RH is of high linearity. The high device repeatability was demonstrated by carrying out vapor adsorption–desorption dynamic cycles, and the response and recovery time were determined to be 64 and 51 min, respectively. These sensing performances given by CNT/Si-NPA are attributed to the unique surface structure, morphology and chemical inertness of the CNT/Si-NPA.

[1]  Jose Maria Kenny,et al.  Sensors for sub-ppm NO2 gas detection based on carbon nanotube thin films , 2003 .

[2]  Riichiro Saito,et al.  Raman spectroscopy of carbon nanotubes , 2005 .

[3]  P. Nordlander,et al.  Unraveling Nanotubes: Field Emission from an Atomic Wire , 1995, Science.

[4]  Kong,et al.  Nanotube molecular wires as chemical sensors , 2000, Science.

[5]  D. Ravinder,et al.  Thermoelectric power studies of gadolinium substituted Mn–Zn–Gd ferrites , 2002 .

[6]  A. Maiti,et al.  Effect of adsorbates on field emission from carbon nanotubes. , 2001, Physical review letters.

[7]  Young-Min Choi,et al.  Investigation of the humidity effect on the electrical properties of single-walled carbon nanotube transistors , 2005 .

[8]  Xinjian Li,et al.  Structural and capacitive humidity sensing properties of nanocrystal magnetite/silicon nanoporous pillar array , 2005 .

[9]  Craig A. Grimes,et al.  Gas sensing characteristics of multi-wall carbon nanotubes , 2001 .

[10]  D. Ravinder,et al.  Thermoelectric power studies of zinc-substituted nickel ferrites , 2000 .

[11]  M. Lundstrom,et al.  Ballistic carbon nanotube field-effect transistors , 2003, Nature.

[12]  Shankar Ghosh,et al.  Carbon Nanotube Flow Sensors , 2003, Science.

[13]  Bingqing Wei,et al.  Miniaturized gas ionization sensors using carbon nanotubes , 2003, Nature.

[14]  D. Ravinder.  Thermoelectric power studies of zinc substituted copper ferrites , 1999 .

[15]  Chen,et al.  High H2 uptake by alkali-doped carbon nanotubes under ambient pressure and moderate temperatures , 1999, Science.

[16]  Saroj K. Nayak,et al.  Effect of H2O adsorption on electron transport in a carbon nanotube , 2002 .

[17]  Xing Hu,et al.  Capacitive humidity sensing properties of hydrothermally-etched silicon nano-porous pillar array , 2005 .

[18]  P. Eklund,et al.  Vibrational modes of carbon nanotubes; Spectroscopy and theory , 1995 .

[19]  Jose Maria Kenny,et al.  Sensitivity to NO2 and cross-sensitivity analysis to NH3, ethanol and humidity of carbon nanotubes thin film prepared by PECVD , 2003 .

[20]  P. Poncharal,et al.  Water-vapor effect on the electrical conductivity of a single-walled carbon nanotube mat , 2000 .

[21]  Byeong Kwon Ju,et al.  A simple approach in fabricating chemical sensor using laterally grown multi-walled carbon nanotubes , 2004 .

[22]  D. Ravinder,et al.  Thermoelectric power studies of polycrystalline magnesium substituted lithium ferrites , 2003 .

[23]  Joseph Wang,et al.  Electrochemical determination of hydrogen sulfide at carbon nanotube modified electrodes , 2004 .

[24]  Yu Jia,et al.  Tunable superstructures in hydrothermally etched iron-passivated porous silicon , 1999 .