A dual-band CMOS front-end with two gain modes for wireless LAN applications

A dual-band front-end with two gain modes operating at the 2.4 Industrial Scientific and Medical (ISM) band and 5.15-GHz Unlicensed National Information Infrastructure (UNII) band has been demonstrated in a 0.18-/spl mu/m foundry CMOS process. The front-end uses a single set of RF blocks. A dual-band low noise amplifier (LNA) with two inputs is tuned to the two resonant frequencies by controlling the voltage on a switched resonator. The same switched resonator is also used to switch the LNA between high-gain and low-gain modes. In the 2.4-GHz high-gain mode, the front-end exhibits 39.8-dB maximum voltage gain, 1.5-dB double-side-band (DSB) noise figure, and -12.7-dBm input-referred IP/sub 3/ (IIP/sub 3/) while consuming 24 mW from a 1.8-V supply. In the 5.15-GHz high-gain mode, the front-end achieves 29.2-dB maximum voltage gain, 4.1-dB DSB noise figure and -4.1-dBm IIP/sub 3/ with 41-mW power consumption. The gains can be switched by 7 dB at 5.15 GHz and by 17 dB at 2.4 GHz.

[1]  K. Halonen,et al.  A dual-band RF front-end for WCDMA and GSM applications , 2001 .

[2]  H. Hashemi,et al.  Concurrent dual-band CMOS low noise amplifiers and receiver architectures , 2001, 2001 Symposium on VLSI Circuits. Digest of Technical Papers (IEEE Cat. No.01CH37185).

[3]  K.O. Kenneth,et al.  A 900-MHz, 0.8-/spl mu/m CMOS low noise amplifier with 1.2-dB noise figure , 1999, Proceedings of the IEEE 1999 Custom Integrated Circuits Conference (Cat. No.99CH36327).

[4]  M. Biyani,et al.  3 V low noise amplifier implemented using a 0.8 /spl mu/m CMOS process with three metal layers for 900 MHz operation , 1996 .

[5]  Brian Floyd,et al.  A CMOS WIRELESS INTERCONNECT SYSTEM FOR MULTIGIGAHERTZ CLOCK DISTRIBUTION , 2001 .

[6]  A. Molnar,et al.  A single-chip quad-band (850/900/1800/1900 MHz) direct-conversion GSM/GPRS RF transceiver with integrated VCOs and fractional-N synthesizer , 2002, 2002 IEEE International Solid-State Circuits Conference. Digest of Technical Papers (Cat. No.02CH37315).

[7]  C. Liss,et al.  An RF CMOS transmitter integrating a power amplifier and a transmit/receive switch for 802.11b wireless local area network applications , 2003, IEEE Radio Frequency Integrated Circuits (RFIC) Symposium, 2003.

[8]  T. Lee,et al.  A 1.5 V, 1.5 GHz CMOS low noise amplifier , 1996 .

[9]  K. O. Kenneth,et al.  Demonstration of a switched resonator concept in a dual-band monolithic CMOS LC-tuned VCO , 2001, Proceedings of the IEEE 2001 Custom Integrated Circuits Conference (Cat. No.01CH37169).

[10]  Xi Li,et al.  A comparison of CMOS and SiGe LNA's and mixers for wireless LAN application , 2001, Proceedings of the IEEE 2001 Custom Integrated Circuits Conference (Cat. No.01CH37169).

[11]  K. O Kenneth.  Design and Analyses of Tuned RF Circuits Including the Effects of Process and Component Variations , 2003 .

[12]  K.K. O,et al.  5.8-GHz CMOS T/R switches with high and low substrate resistances in a 0.18-μm CMOS process , 2003, IEEE Microwave and Wireless Components Letters.

[13]  Zhenbiao Li,et al.  5.8-GHz CMOS T/R switches with high and low substrate resistances in a 0.18-μm CMOS process , 2003 .

[14]  Robert W. Dutton,et al.  A noise optimization technique for integrated low-noise amplifiers , 2002, IEEE J. Solid State Circuits.

[15]  K. O,et al.  A 900-MHz 1.5-V CMOS voltage-controlled oscillator using switched resonators with a wide tuning range , 2003, IEEE Microwave and Wireless Components Letters.