Entropy Change Characteristics of the LiNi0.5Mn1.5O4 Cathode Material for Lithium-Ion Batteries

Lithium-ion batteries are widely used in the field of new energy vehicles and energy storage. Understanding the electrode reaction of lithium-ion batteries is the key to improve their cycle life and safety. Direct measurement of thermodynamic data of the electrode reaction is a practical, economical, and nondestructive method for electrode characterization. In this paper, the open-circuit voltage of the LiNi0.5Mn1.5O4/Li half-cell is measured at different discharge states and different temperatures. The dE/dT–SOD (state of discharge) relation curves are fitted linearly by the least square method, and the entropy change values of different SODs are calculated. Finally, the Gibbs free energy and enthalpy change of different SODs are obtained. The electrode reaction of LiNi0.5Mn1.5O4 in different SODs was discussed by the entropy change in different SODs. According to the evolution trend of ΔS, the lithium intercalation reaction of LiNi0.5Mn1.5O4 may be a single-phase solid solution reaction rather than a two-phase reaction. Finally, the reversible heat generation at different current values and SODs are calculated.

[1]  Shanhai Ge,et al.  Asymmetric Temperature Modulation for Extreme Fast Charging of Lithium-Ion Batteries , 2019 .

[2]  J. Tarascon,et al.  Probing the thermal effects of voltage hysteresis in anionic redox-based lithium-rich cathodes using isothermal calorimetry , 2019, Nature Energy.

[3]  Seung-wook Eom,et al.  Entropy measurement of a large format lithium ion battery and its application to calculate heat generation , 2019, Electrochimica Acta.

[4]  Hongyu Dong,et al.  Improved High Temperature Performance of a Spinel LiNi0.5Mn1.5O4 Cathode for High-Voltage Lithium-Ion Batteries by Surface Modification of a Flexible Conductive Nanolayer , 2019, ACS omega.

[5]  William E. Gent,et al.  High Reversibility of Lattice Oxygen Redox Quantified by Direct Bulk Probes of Both Anionic and Cationic Redox Reactions , 2018, Joule.

[6]  Xiangyun Song,et al.  Structural evolution and capacity degradation mechanism of LiNi0.6Mn0.2Co0.2O2 cathode materials , 2018, Journal of Power Sources.

[7]  Michael Pecht,et al.  Li-Ion Battery Fire Hazards and Safety Strategies , 2018, Energies.

[8]  Jun Lu,et al.  30 Years of Lithium‐Ion Batteries , 2018, Advanced materials.

[9]  Hongwei Wu,et al.  Experimental and analytical study on heat generation characteristics of a lithium-ion power battery , 2018, International Journal of Heat and Mass Transfer.

[10]  Akhil Garg,et al.  Design optimization of battery pack enclosure for electric vehicle , 2018 .

[11]  Tang Yiwei,et al.  Study of the thermal properties during the cyclic process of lithium ion power batteries using the electrochemical-thermal coupling model , 2018, Applied Thermal Engineering.

[12]  Yi Cui,et al.  Materials for lithium-ion battery safety , 2018, Science Advances.

[13]  Jie Deng,et al.  Safety modelling and testing of lithium-ion batteries in electrified vehicles , 2018 .

[14]  Wei Li,et al.  A review of safety-focused mechanical modeling of commercial lithium-ion batteries , 2018 .

[15]  Teng Zhang,et al.  Potentiometric measurement of entropy change for lithium batteries. , 2017, Physical chemistry chemical physics : PCCP.

[16]  V. Battaglia,et al.  The effect of cobalt doping on the morphology and electrochemical performance of high-voltage spinel LiNi0.5Mn1.5O4 cathode material , 2016 .

[17]  Surface and Interface Issues in Spinel LiNi0.5Mn1.5O4: Insights into a Potential Cathode Material for High Energy Density Lithium Ion Batteries , 2016 .

[18]  V. Battaglia,et al.  Effect of Chromium and Niobium Doping on the Morphology and Electrochemical Performance of High-Voltage Spinel LiNi(0.5)Mn(1.5)O4 Cathode Material. , 2016, ACS applied materials & interfaces.

[19]  Songrui Wang,et al.  Entropy and heat generation of lithium cells/batteries , 2016 .

[20]  B. Polzin,et al.  The Effect of Entropy and Enthalpy Changes on the Thermal Behavior of Li-Mn-Rich Layered Composite Cathode Materials , 2016 .

[21]  Jung-Hyun Kim,et al.  Direct Experimental Probe of the Ni(II)/Ni(III)/Ni(IV) Redox Evolution in LiNi0.5Mn1.5O4 Electrodes , 2015 .

[22]  V. Battaglia,et al.  Revealing and suppressing surface Mn(II) formation of Na0.44MnO2 electrodes for Na-ion batteries , 2015 .

[23]  Y. Orikasa,et al.  Solid Solution Domains at Phase Transition Front of LixNi0.5Mn1.5O4 , 2015 .

[24]  T. Baumbach,et al.  In operando study of the high voltage spinel cathode material LiNi(0.5)Mn(1.5)O4 using two dimensional full-field spectroscopic imaging of Ni and Mn. , 2015, Physical chemistry chemical physics : PCCP.

[25]  K. Jalkanen,et al.  Entropy change characteristics of LiMn0.67Fe0.33PO4 and Li4Ti5O12 electrode materials , 2015 .

[26]  J. Newman,et al.  Simulation of temperature rise in Li-ion cells at very high currents , 2014 .

[27]  Guoying Chen,et al.  Relationships between Mn3+ Content, Structural Ordering, Phase Transformation, and Kinetic Properties in LiNixMn2–xO4 Cathode Materials , 2014 .

[28]  Christopher S. Johnson,et al.  Insight into the structural evolution of a high-voltage spinel for lithium-ion batteries , 2014 .

[29]  Arumugam Manthiram,et al.  A perspective on the high-voltage LiMn1.5Ni0.5O4 spinel cathode for lithium-ion batteries , 2014 .

[30]  Bharat Bhushan,et al.  In situ electrochemical studies of lithium-ion battery cathodes using atomic force microscopy , 2014 .

[31]  K. Jalkanen,et al.  Entropy change effects on the thermal behavior of a LiFePO4/graphite lithium-ion cell at different states of charge , 2013 .

[32]  A. Mauger,et al.  Review of 5-V electrodes for Li-ion batteries: status and trends , 2013, Ionics.

[33]  Jing Mao,et al.  Electrochemical studies of spinel LiNi0.5Mn1.5O4 cathodes with different particle morphologies , 2012 .

[34]  J. Goodenough,et al.  Challenges for Rechargeable Li Batteries , 2010 .

[35]  Yo Kobayashi,et al.  Configurational Entropy of Lithium Manganese Oxide and Related Materials, LiCr y Mn2 − y O4 ( y = 0 , 0.3 ) , 2008 .

[36]  B. Fultz,et al.  Entropymetry of Lithium Intercalation in Spinel Manganese Oxide: Effect of Lithium Stoichiometry , 2006 .

[37]  M. Whittingham,et al.  Lithium batteries and cathode materials. , 2004, Chemical reviews.

[38]  M. Armand,et al.  Issues and challenges facing rechargeable lithium batteries , 2001, Nature.

[39]  Karen E. Thomas,et al.  Measurement of the Entropy of Reaction as a Function of State of Charge in Doped and Undoped Lithium Manganese Oxide , 2001 .

[40]  J. Newman,et al.  Thermal Modeling of the Lithium/Polymer Battery .1. Discharge Behavior of a Single-Cell , 1995 .

[41]  J. Pereira‐Ramos,et al.  A thermodynamic, structural and kinetic study of the electrochemical lithium intercalation into the xerogel V2O5 · 1.6 H2O in a propylene , 1991 .

[42]  J. Wit,et al.  The thermodynamic and thermoelectric properties of LixTiS2 and LixCoO2 , 1984 .