Detection and assessment of wood decay in glulam beams using a through-transmission ultrasonic approach

A glulam beam retired from the field and without visible indications of wood decay was used. Towards detection and assessing wood decay, X-ray computer tomography and ultrasonic measurements were carried out. It was observed that decrease in mass density with increasing levels of wood decay affects x-rays attenuation and allows radioscopy to detect and assess wood decay. Furthermore, it was also observed that the decrease in mass density and stiffness caused by wood decay affects ultrasonics measurements. It was observed that ultrasonic velocity and stress wave features such as time of arrival, area under the power spectral density curve, energy, and frequency of maximum amplitude allows detection and assessment of wood decay. Results show that results from both X-ray computer tomography and ultrasonic measurements are consistent with each other and can be used to detect and assess wood decay in structural lumber.

[1]  F. Beall,et al.  Relationship of acoustic emission during radial compression to mass loss from decay , 1987 .

[2]  Voichita Bucur,et al.  An ultrasonic method for measuring the elastic constants of wood increment cores bored from living trees , 1983 .

[3]  Daniel A. Kuchma,et al.  Estimation of general corrosion damage to steel reinforced mortar using frequency sweeps of guided mechanical waves , 2006 .

[4]  Daniel A. Kuchma,et al.  Estimation of corrosion damage in steel reinforced mortar using waveguides , 2005, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[5]  S. Quarles.  The effect of moisture content and ring angle on the propagation of acoustic signals in wood , 1990 .

[6]  Minamisawa Akiko,et al.  Measurement of Moisture Diffusivity in Woods using Ultrasounds. , 1994 .

[7]  W. L. James.  Effect of Transverse Moisture Content Gradients on the Longitudinal Propagation of Sound in Wood , 2001 .

[8]  J. Bryce.  Southern Forest Experiment Station , 1989 .

[9]  R. Zabel,et al.  Wood Microbiology: Decay and Its Prevention , 1993 .

[10]  H. Suzuki,et al.  Effect of grain angle on the ultrasonic velocity of wood. , 1990 .

[11]  J. I. Dunlop.  Testing of poles by acoustic resonance , 2004, Wood Science and Technology.

[12]  J. I. Dunlop.  Testing of poles by using acoustic pulse method , 2004, Wood Science and Technology.

[13]  Roy F. Pellerin,et al.  Nondestructive stress wave measurements of decay and termite attack in experimental wood units , 1986 .

[14]  V. Bucur,et al.  Elastic constants for wood by an ultrasonic method , 1984, Wood Science and Technology.

[15]  H. Sakai,et al.  Effect of moisture content on ultrasonic velocity and attenuation in woods , 1990 .

[16]  A. Vary.  The Acousto-Ultrasonic Approach , 1988 .

[17]  D. A. Dornfeld,et al.  Preliminary investigation of the feasibility of using acousto-ultrasonics to measure defects in lumber , 1988 .

[18]  J. Rose.  Ultrasonic Waves in Solid Media , 1999 .

[19]  Jacob L. Borgerson,et al.  Torsional waveguide sensor system for monitoring the setting and hardening of concrete , 2007 .

[20]  Kent A. McDonald,et al.  Defect detection in lumber: state of the art , 1981 .

[21]  R. S. Olivito.  Ultrasonic measurements in wood , 1996 .

[22]  Utility pole decay — Part I: Appraisal of a device for nondestructive detection of decay , 1968, Wood Science and Technology.

[23]  Jacob L. Borgerson,et al.  Monitoring the setting and hardening of early-age mortar using a pulse-echo ultrasonic guided wave approach , 2007 .

[24]  W. Wilcox,et al.  Detection of early stages of wood decay with ultrasonic pulse velocity , 1988 .

[25]  F. Beall,et al.  Acousto-Ultrasonic Assessment of Internal Decay in Glulam Beams , 2007 .

[26]  Frank C. Beall,et al.  The use of acousto-ultrasonics to detect biodeterioration in utility poles , 1994 .

[27]  C. Gerhards,et al.  Longitudinal stress waves for lumber stress grading: factors affecting applications: state of the art , 1982 .

[28]  D. Bray,et al.  A Critical-Angle Ultrasonic Technique for the Inspection of Wood Parallel-to-Grain , 1996 .

[29]  A. Mishiro.  Effect of density on ultrasonic velocity in wood , 1996 .

[30]  Elena Comino,et al.  FEASIBILITY OF ULTRASONIC TOMOGRAPHY FOR NONDESTRUCTIVE TESTING OF DECAY ON LIVING TREES , 2004 .

[31]  J. L. Sandoz,et al.  Grading of construction timeber by ultrasound , 1989, Wood Science and Technology.

[32]  A. Vary.  Analytical Ultrasonics in Materials Research and Testing , 1986 .