Lamb wave generation using nanosecond laser ablation to detect damage

This paper proposes a non-contact damage detection method based on Lamb waves generated by laser ablation (LA). Previously, Lamb waves generated by contact-type sensors such as acoustic emission or piezoelectric zirconate titanate devices have been studied to detect damage. Lamb wave generation systems with embedded contact-type excitation devices to objective structures to be inspected may quickly realize large-area damage detection on a huge object such as an aircraft. However, replacing contact-type devices with non-contact devices in Lamb wave generation systems, the systems will have sufficient potential to excite under the specific conditions such as submerged target structures in liquid and high-temperature substances. The LA-generated Lamb waves that have amplitudes several hundred times larger than those generated by conventional laser-thermoelastically generated Lamb waves are of advantage from the viewpoint of the signal-to-noise ratio in the measurements. When the laser fluence reaches 1012–1014 W/m2, which is greater than that for laser-thermoelastic regime, a LA regime is induced. The amplitudes of the LA-generated Lamb waves might be higher than those of the laser-thermoelastically generated Lamb waves; this is within the scope of the assumption. Since the LA process entails a number of nonlinear processes such as melting, vaporization, and sublimation, it is important to confirm that LA could generate a Lamb wave and its mode. In this paper, Lamb waves that contain broadband frequency elements of more than several hundred kHz are generated by non-contact impulse excitation using LA, which is common in vibration tests in the high-frequency range, laser peening, propulsion of micro-aircraft, bolt loosening diagnosis, etc. The present method is evaluated by comparing the measured and calculated propagation phase and group velocities of the Lamb waves. Furthermore, the feasibility of our approach is demonstrated by non-contact damage detection against an aluminum alloy 2024 plate with a crack.

[1]  Óscar Martínez-Graullera,et al.  Lamb mode diversity imaging for non-destructive testing of plate-like structures , 2013 .

[2]  Piervincenzo Rizzo,et al.  Semi-analytical formulation for the guided waves-based reconstruction of elastic moduli , 2011 .

[3]  Jing Lin,et al.  Chirp-based dispersion pre-compensation for high resolution Lamb wave inspection , 2014 .

[4]  C. Prada,et al.  Laser impulse generation and interferometer detection of zero group velocity Lamb mode resonance , 2006 .

[5]  Michel Castaings,et al.  ULTRASONIC GUIDED WAVES FOR HEALTH MONITORING OF HIGH PRESSURE COMPOSITE TANKS , 2008 .

[6]  Tadeusz Uhl,et al.  Bayesian parameter identification of orthotropic composite materials using Lamb waves dispersion curves measurement , 2017 .

[7]  T. Yabe,et al.  Microairplane propelled by laser driven exotic target , 2002 .

[8]  Itsuro Kajiwara,et al.  Non-contact acoustic tests based on nanosecond laser ablation: Generation of a pulse sound source with a small amplitude , 2014 .

[9]  F. Lepoutre,et al.  Numerical predictions and experiments for optimizing hidden corrosion detection in aircraft structures using Lamb modes. , 2007, Ultrasonics.

[10]  A. Baltazar,et al.  Characterization of Laser Generated Lamb Wave Modes after Interaction with a Thickness Reduction Discontinuity Using Ray Tracing Theory , 2014 .

[11]  Naoki Hosoya,et al.  High spatial and temporal resolution measurement of mechanical properties in hydrogels by non-contact laser excitation , 2016 .

[12]  Lingyu Yu,et al.  Lamb wave Structural Health Monitoring Using a Hybrid PZT-Laser Vibrometer Approach , 2013 .

[13]  Lin Ye,et al.  Guided Lamb waves for identification of damage in composite structures: A review , 2006 .

[14]  P. Glynne-Jones,et al.  Time-resolved full-field imaging of ultrasonic Lamb waves using deflectometry , 2016 .

[15]  F. Yuan,et al.  A rapid, fully non-contact, hybrid system for generating Lamb wave dispersion curves. , 2015, Ultrasonics.

[16]  Srinivasan Gopalakrishnan,et al.  Rapid localization of damage using a circular sensor array and Lamb wave based triangulation , 2010 .

[17]  C. Prada,et al.  Characterization of mechanical properties of a hollow cylinder with zero group velocity Lamb modes. , 2012, The Journal of the Acoustical Society of America.

[18]  Ning Hu,et al.  An Efficient Algorithm Embedded in an Ultrasonic Visualization Technique for Damage Inspection Using the AE Sensor Excitation Method , 2014, Sensors.

[19]  Daniele Margarone,et al.  Study on the ablation threshold induced by pulsed lasers at different wavelengths , 2007 .

[20]  J. Rose.  Ultrasonic Waves in Solid Media , 1999 .

[21]  Minoru Obara,et al.  Optical vibration sensor fabricated by femtosecond laser micromachining , 2005 .

[22]  Itsuro Kajiwara,et al.  Vibration testing based on impulse response excited by laser ablation , 2011 .

[23]  R. Singh,et al.  Laser deposition of diamondlike carbon films at high intensities , 1995 .

[24]  Itsuro Kajiwara,et al.  Damage Detection in Transparent Materials Using Non-Contact Laser Excitation by Nano-Second Laser Ablation and High-Speed Polarization-imaging Camera , 2016 .

[25]  Itsuro Kajiwara,et al.  Nano-second Laser-induced Plasma Shock Wave in Air for Non-contact Vibration Tests , 2016 .

[26]  I. Charles Ume,et al.  Fundamental study of laser generation of narrowband Lamb waves using superimposed line sources technique , 2011 .

[27]  A. Jankauskas,et al.  Investigation of the Lamb Waves Generation in Isotropic Plates Using Ultrasonic Broadband Transducers , 2013 .

[28]  Marek Krawczuk,et al.  Damage localisation in a stiffened plate structure using a propagating wave , 2013 .

[29]  Itsuro Kajiwara,et al.  Bolt loosening analysis and diagnosis by non-contact laser excitation vibration tests , 2013 .

[30]  Rolf Lammering.  Observation of Piezoelectrically Induced Lamb Wave Propagation in Thin Plates by Use of Speckle Interferometry , 2010 .

[31]  Daniel Cernadas,et al.  Non-destructive testing of plates based on the visualisation of Lamb waves by double-pulsed TV holography , 2006 .

[32]  Itsuro Kajiwara,et al.  Dynamic characterizations of underwater structures using non-contact vibration test based on nanosecond laser ablation in water: investigation of cavitation bubbles by visualizing shockwaves using the Schlieren method , 2016 .

[33]  Christian Willberg,et al.  Experimental and Theoretical Analysis of Lamb Wave Generation by Piezoceramic Actuators for Structural Health Monitoring , 2012 .

[34]  Wieslaw Ostachowicz,et al.  Damage detection potential of a triangular piezoelectric configuration , 2011 .

[35]  Samir Mustapha,et al.  Debonding Detection in Composite Sandwich Structures Based on Guided Waves , 2012 .

[36]  I. Kajiwara,et al.  Vibration testing based on impulse response excited by pulsed-laser ablation: Measurement of frequency response function with detection-free input , 2012 .

[37]  Omar Hatamleh,et al.  Effects of peening on mechanical properties in friction stir welded 2195 aluminum alloy joints , 2008 .