论文信息 - Modeling validation and MPPT technique of small wind PMSG turbines using DSPACE hardware

Modeling validation and MPPT technique of small wind PMSG turbines using DSPACE hardware

This paper describes the optimization of a PMSG wind turbine with an internal rectifier connected to a DC-DC converter (BOOST) and a resistive load. Firstly, an experimental validation of our wind turbine model is performed, and then some tests cases were conducted in order to deduce the MPPT control law. The simulation was performed using Matlab / Simulink tools, while the experimental implementation of the MPPT control has been done on a DSPACE card 1104. The obtained results show promising relevance of our proposed method.

Smail Zouggar | Mohamed Larbi Elhafyani | Badreddine Lahfaoui | Anas Benslimane

[1] Mohammed Ouassaid,et al. Control of a PMSG based wind energy generation system for power maximization and grid fault conditions , 2013 .

[2] Smail Zouggar,et al. Experimental modeling and control of a small wind PMSG turbine , 2014, 2014 International Renewable and Sustainable Energy Conference (IRSEC).

[3] Chih-Ming Hong,et al. Maximum power point tracking-based control algorithm for PMSG wind generation system without mechanical sensors , 2013 .

[4] Saad Mekhilef,et al. A novel MPPT algorithm for load protection based on output sensing control , 2011, 2011 IEEE Ninth International Conference on Power Electronics and Drive Systems.

[5] P.L. Chapman,et al. Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[6] Abdullah M. Noman,et al. Simulation and dSPACE hardware implementation of the MPPT techniques using buck boost converter , 2013, 2013 Africon.

[7] A. Rabhi,et al. A STAND-ALONE SYSTEM ENERGY HYBRID COMBINING WIND AND PHOTOVOLTAIC WITH VOLTAGE CONTROL « FEEDBACK LOOP VOLTAGE » , 2010 .