A 104-dB Dynamic Range Transimpedance-Based CMOS ASIC for Tuning Fork Microgyroscopes

In this paper, the design, implementation and characterization of a continuous time transimpedance-based ASIC for the actuation and sensing of a high-Q MEMS tuning fork gyroscope (TFG) is presented. A T-network transimpedance amplifier (TIA) is used as the front-end for low-noise, sub-atto-Farad capacitive detection. The T-network TIA provides on-chip transimpedance gains of up to 25 MOmega, has a measured capacitive resolution of 0.02 aF/radicHz at 15 kHz, a wide dynamic range of 104 dB in a bandwidth of 10 Hz and consumes 400 muW of power. The CMOS interface ASIC uses this TIA as the front-end to sustain electromechanical oscillations in a MEMS TFG with motional impedance greater than 10 MOmega. The TFG interfaced with the ASIC yields a two-chip angular rate sensor with measured rate noise floor of 2.7deg/hr/radicHz, bias instability of 1deg/hr and rate sensitivity of 2 mV/deg/s. The IC is fabricated in a 0.6-mum standard CMOS process with an area of 2.25 mm2 and consumes 15 mW.

[1]  Farrokh Ayazi,et al.  A two-chip, 4-MHz, microelectromechanical reference oscillator , 2005, 2005 IEEE International Symposium on Circuits and Systems.

[2]  R. Neul,et al.  New surface micromachined angular rate sensor for vehicle stabilizing systems in automotive applications , 2005, The 13th International Conference on Solid-State Sensors, Actuators and Microsystems, 2005. Digest of Technical Papers. TRANSDUCERS '05..

[3]  F. Ayazi,et al.  High Performance Matched-Mode Tuning Fork Gyroscope , 2006, 19th IEEE International Conference on Micro Electro Mechanical Systems.

[4]  K. Najafi,et al.  A HARPSS polysilicon vibrating ring gyroscope , 2001 .

[5]  Kari Halonen,et al.  Fully integrated charge sensitive amplifier for readout of micromechanical capacitive sensors , 2005, 2005 IEEE International Symposium on Circuits and Systems.

[6]  G.K. Fedder,et al.  A low-noise low-offset capacitive sensing amplifier for a 50-/spl mu/g//spl radic/Hz monolithic CMOS MEMS accelerometer , 2004, IEEE Journal of Solid-State Circuits.

[7]  J.H. Smith,et al.  A 3-axis surface micromachined /spl Sigma//spl Delta/ accelerometer , 1997, 1997 IEEE International Solids-State Circuits Conference. Digest of Technical Papers.

[8]  Jerald Graeme,et al.  Photodiode Amplifiers: OP AMP Solutions , 1995 .

[9]  T. Gabrielson.  Mechanical-thermal noise in micromachined acoustic and vibration sensors , 1993 .

[10]  R. Howe,et al.  An integrated CMOS micromechanical resonator high-Q oscillator , 1999, IEEE J. Solid State Circuits.

[11]  Robert G. Meyer,et al.  Analysis and Design of Analog Integrated Circuits , 1993 .

[12]  Farrokh Ayazi,et al.  A 0.2°/hr Micro-Gyroscope with Automatic CMOS Mode Matching , 2007, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[13]  G. Fedder,et al.  A Low-Noise Low-Offset Capacitive Sensing Amplifier for a 50-g = Hz Monolithic CMOS MEMS Accelerometer , 2004 .

[14]  R. R. Harrison,et al.  A low-power low-noise CMOS amplifier for neural recording applications , 2003, IEEE J. Solid State Circuits.

[15]  Farrokh Ayazi,et al.  Micromachined inertial sensors , 1998, Proc. IEEE.

[16]  William C. Tang,et al.  Electrostatic-comb drive of lateral polysilicon resonators , 1990 .

[17]  B. Boser,et al.  A monolithic surface micromachined Z-axis gyroscope with digital output , 2000, 2000 Symposium on VLSI Circuits. Digest of Technical Papers (Cat. No.00CH37103).

[18]  G. K. Ho,et al.  High-Q single crystal silicon HARPSS capacitive beam resonators with self-aligned sub-100-nm transduction gaps , 2003 .

[19]  Farrokh Ayazi,et al.  A 104dB SNDR Transimpedance-based CMOS ASIC for Tuning Fork Microgyroscopes , 2006, IEEE Custom Integrated Circuits Conference 2006.

[20]  Gabor C. Temes,et al.  Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilization , 1996, Proc. IEEE.

[21]  M. Lemkin.  A 3-Axis Surface Micromachined Σ ∆ Accelerometer Regular Paper-Session 12 , 1999 .

[22]  F. Ayazi,et al.  A 2.5-V 14-bit /spl Sigma//spl Delta/ CMOS SOI capacitive accelerometer , 2004, IEEE Journal of Solid-State Circuits.

[23]  Bernhard E. Boser,et al.  17.6 A Fourth-Order Σ∆ Interface for Micromachined Inertial Sensors , 2004 .

[24]  M. W. Putty.  A Maicromachined vibrating ring gyroscope , 1994 .

[25]  S. Sherman,et al.  Single-chip surface micromachined integrated gyroscope with 50°/h Allan deviation , 2002, IEEE J. Solid State Circuits.

[26]  Christopher C. T. Nguyen,et al.  Influence of automatic level control on micromechanical resonator oscillator phase noise , 2003, IEEE International Frequency Control Symposium and PDA Exhibition Jointly with the 17th European Frequency and Time Forum, 2003. Proceedings of the 2003.

[27]  R. Howe,et al.  CMOS micromechanical resonator oscillator , 1993, Proceedings of IEEE International Electron Devices Meeting.