Common-Mode Noise Current Simulation and Measurement on a Gate Driver for SiC MOSFET Half-Bridge Modules

Fast switching transitions of the SiC MOSFET power semiconductor devices, can cause abundance of issues due to injected common-mode (CM) noise current through gate driver, possibly preventing converter successful operation. Therefore, this paper presents a detailed methodology of simulation and new measurement method of CM noise current on a gate driver. For simulation, detailed consideration of circuit parasitics (inductances, resistances and capacitances) is included and analyzed. Considering measurement, small high-precision chip resistors are utilized to measure the CM noise current. The results achieved by simulation and measurement are in agreement. This method is applied to design a novel gate driver for 1.7 kV SiC MOSFET half-bridge module having "on-board communication" between top and bottom devices. By comparing different options, simple communication by a digital isolator is deemed the best. As this paper illustrates, proposed method of evaluating and measuring the noise is useful to design new gate drivers.

[1]  Philippe Godignon,et al.  A Survey of Wide Bandgap Power Semiconductor Devices , 2014, IEEE Transactions on Power Electronics.

[2]  Lee Gill,et al.  Analysis and Mitigation of Common Mode Current in SiC MOSFET Gate Driver Power Supply , 2018, 2018 IEEE International Conference on Electrical Systems for Aircraft, Railway, Ship Propulsion and Road Vehicles & International Transportation Electrification Conference (ESARS-ITEC).

[3]  Dushan Boroyevich,et al.  Power Electronics Building Block (PEBB) design based on 1.7 kV SiC MOSFET modules , 2017, 2017 IEEE Electric Ship Technologies Symposium (ESTS).

[4]  Dushan Boroyevich,et al.  Gate driver design for 1.7kV SiC MOSFET module with Rogowski current sensor for shortcircuit protection , 2016, 2016 IEEE Applied Power Electronics Conference and Exposition (APEC).

[5]  Deepak Divan,et al.  High speed switching issues of high power rated silicon-carbide devices and the mitigation methods , 2015, 2015 IEEE Energy Conversion Congress and Exposition (ECCE).

[6]  Dushan Boroyevich,et al.  Phase Current Sensor and Short-Circuit Detection based on Rogowski Coils Integrated on Gate Driver for 1.2 kV SiC MOSFET Half-Bridge Module , 2018, 2018 IEEE Energy Conversion Congress and Exposition (ECCE).

[7]  Hideaki Fujita,et al.  A resonant gate-drive circuit with optically-isolated control signal and power supply for fast-switching and high-voltage power semiconductor devices , 2013, The 2010 International Power Electronics Conference - ECCE ASIA -.

[8]  Dushan Boroyevich,et al.  High-Scalability Enhanced Gate Drivers for SiC MOSFET Modules With Transient Immunity Beyond 100 V/ns , 2020, IEEE Transactions on Power Electronics.