Shear-Induced Structure Formation in MAH-g-PP Compatibilized Polypropylenes

[1]  L. V. van Breemen,et al.  Synergy of Fiber Surface Chemistry and Flow: Multi-Phase Transcrystallization in Fiber-Reinforced Thermoplastics , 2022, Polymers.

[2]  A. Müller,et al.  Experimental and Data Fitting Guidelines for the Determination of Polymer Crystallization Kinetics , 2022, Chinese Journal of Polymer Science.

[3]  Stan F. S. P. Looijmans,et al.  An experimentally validated model for quiescent multiphase primary and secondary crystallization phenomena in PP with low content of ethylene comonomer , 2022, Polymer.

[4]  L. Simon‐Stőger,et al.  Remarkable Role of Experimental Olefin-Maleic-Anhydride Copolymer Based Compatibilizing Additives in Blends of Waste PET Bottles and Polyamide , 2020, Waste and Biomass Valorization.

[5]  R. Velmurugan,et al.  Development of efficient short/continuous fiber thermoplastic composite automobile suspension upper control arm , 2020 .

[6]  J. Thomason.  Glass fibre sizing: A review , 2019, Composites Part A: Applied Science and Manufacturing.

[7]  G. Peters,et al.  Modelling flow induced crystallization of IPP: Multiple crystal phases and morphologies , 2019, Polymer.

[8]  Wei Chen,et al.  A general strength model for fiber bundle composites under transverse tension or interlaminar shear , 2019, Composites Part A: Applied Science and Manufacturing.

[9]  S. Tanoue,et al.  Effect of maleic anhydride-grafted polypropylene on the flow orientation of short glass fiber in molten polypropylene and on tensile properties of composites , 2018 .

[10]  G. Peters,et al.  Deformation-Induced Phase Transitions in iPP Polymorphs , 2017, Polymers.

[11]  G. Peters,et al.  Deformation and failure kinetics of iPP polymorphs , 2017 .

[12]  W. Liang,et al.  Coupling effects of glass fiber treatment and matrix modification on the interfacial microstructures and the enhanced mechanical properties of glass fiber/polypropylene composites , 2017 .

[13]  Dashan Mi,et al.  A new insight into the effect of β modification on the mechanical properties of iPP: The role of crystalline morphology , 2016 .

[14]  S. Iannace,et al.  Mechanical performance optimization through interface strength gradation in PP/glass fibre reinforced composites , 2015 .

[15]  Daohai Zhang,et al.  Mechanical Properties and Morphology of Polypropylene/Polypropylene-g-Maleic Anhydride/Long Glass Fiber Composites , 2015 .

[16]  G. Peters,et al.  Short-Term Flow Induced Crystallization in Isotactic Polypropylene: How Short Is Short? , 2013 .

[17]  Changyu Shen,et al.  Enhanced β-crystal formation of isotactic polypropylene under the combined effects of acid-corroded glass fiber and preshear , 2013 .

[18]  J. Torkelson,et al.  Maleic anhydride functionalization of polypropylene with suppressed molecular weight reduction via solid-state shear pulverization , 2013 .

[19]  R. Girolamo,et al.  Morphology and Mechanical Properties of the Mesomorphic Form of Isotactic Polypropylene in Stereodefective Polypropylene , 2013 .

[20]  F. D. Santis,et al.  Nucleation density and growth rate of polypropylene measured by calorimetric experiments , 2013, Journal of Thermal Analysis and Calorimetry.

[21]  Min Zhang,et al.  Synthesis and Characterization of Maleic Anhydride Grafted Polypropylene with a Well-Defined Molecular Structure , 2013 .

[22]  H. Deng,et al.  Realizing the enhancement of interfacial interaction in semicrystalline polymer/filler composites via interfacial crystallization , 2012 .

[23]  G. G. Peters,et al.  Quantification of non-isothermal, multi-phase crystallization of isotactic polypropylene: the influence of cooling rate and pressure , 2012 .

[24]  S. Barbosa,et al.  Glass Fiber Reinforced Polypropylene Mechanical Properties Enhancement by Adhesion Improvement , 2012, Materials.

[25]  Liu Yang,et al.  Temperature dependence of the interfacial shear strength in glass–fibre polypropylene composites , 2011 .

[26]  H. Niu,et al.  Enhancement of graft yield and control of degradation during polypropylene maleation in the presence of polyfunctional monomer , 2011 .

[27]  G. Lamberti.  Isotactic polypropylene crystallization: Analysis and modeling , 2011 .

[28]  Shouke Yan,et al.  Surface-Induced Polymer Crystallization and the Resultant Structures and Morphologies , 2011 .

[29]  Bobing He,et al.  Effects of Compatibilizers on Mechanical Properties of Long Glass Fiber-Reinforced Polypropylene: , 2010 .

[30]  Wei Yang,et al.  Effect of temperature gradient on the development of β phase polypropylene in dynamically vulcanized PP/EPDM blends , 2009 .

[31]  G. G. Peters,et al.  Saturation of Pointlike Nuclei and the Transition to Oriented Structures in Flow-Induced Crystallization of Isotactic Polypropylene , 2009 .

[32]  Gwm Gerrit Peters,et al.  A Novel Dilatometer for PVT Measurements of Polymers at High Cooling – and Shear Rates , 2009 .

[33]  G. G. Peters,et al.  Dilatometry: A Tool to Measure the Influence of Cooling Rate and Pressure on the Phase Behavior of Nucleated Polypropylene , 2009 .

[34]  D. Gray.  Transcrystallization of polypropylene at cellulose nanocrystal surfaces , 2008 .

[35]  Lingbo Zhu,et al.  Polymer transcrystallinity induced by carbon nanotubes , 2008 .

[36]  Sumin Kim,et al.  The effect of types of maleic anhydride-grafted polypropylene (MAPP) on the interfacial adhesion properties of bio-flour-filled polypropylene composites , 2007 .

[37]  A. Müller,et al.  DSC isothermal polymer crystallization kinetics measurements and the use of the Avrami equation to fit the data: Guidelines to avoid common problems , 2007 .

[38]  P. Puyvelde,et al.  Evaluation and comparison of routes to obtain pressure coefficients from high-pressure capillary rheometry data , 2007 .

[39]  M. Sain,et al.  Injection-molded short hemp fiber/glass fiber-reinforced polypropylene hybrid composites—Mechanical, water absorption and thermal properties , 2007 .

[40]  Q. Fu,et al.  Facilitating transcrystallization of polypropylene/glass fiber composites by imposed shear during injection molding , 2006 .

[41]  Hong Tan,et al.  Shear Enhanced Fiber Orientation and Adhesion in PP/Glass Fiber Composites , 2006 .

[42]  Gerrit W. M. Peters,et al.  Influence of shear flow on the specific volume and the crystalline morphology of isotactic polypropylene , 2006 .

[43]  Rui Huang,et al.  On transcrystallinity in semi-crystalline polymer composites , 2005 .

[44]  M. Hillmyer,et al.  Post-polymerization functionalization of polyolefins. , 2005, Chemical Society reviews.

[45]  T. J Keener,et al.  Maleated coupling agents for natural fibre composites , 2004 .

[46]  C. Panayiotou,et al.  Use of silane agents and poly(propylene-g-maleic anhydride) copolymer as adhesion promoters in glass fiber/polypropylene composites , 2001 .

[47]  A. Nogales,et al.  Structure Development during Shear Flow Induced Crystallization of i-PP: In Situ Wide-Angle X-ray Diffraction Study , 2001 .

[48]  A. Okada,et al.  Preparation and Mechanical Properties of Polypropylene−Clay Hybrids , 1997 .

[49]  H. Wagner,et al.  Stress Transfer Efficiency in Semicrystalline-Based Composites Comprising Transcrystalline Interlayers , 1997 .

[50]  H. D. Groot,et al.  13C NMR Study of the Grafting of Maleic Anhydride onto Polyethene, Polypropene, and Ethene−Propene Copolymers , 1996 .

[51]  B. Brulé,et al.  ON THE PRESSURE DEPENDENCY OF THE VISCOSITY OF MOLTEN POLYMERS , 1994 .

[52]  P. Zoller,et al.  Crystallization of polypropylene, nylon‐66 and poly(ethylene terephthalate) at pressures to 200 MPa: Kinetics and characterization of products , 1994 .

[53]  A. J. Lovinger,et al.  Structure of .beta.-Isotactic Polypropylene: A Long-Standing Structural Puzzle , 1994 .

[54]  D. Lohse,et al.  Graft copolymer compatibilizers for blends of isotactic polypropylene and ethene-propene copolymers. 2. Functional polymers approach , 1993 .

[55]  B. Hsiao,et al.  The effects of transcrystalline interphase in advanced polymer composites , 1992 .

[56]  S. V. Meille,et al.  Non-parallel chains in crystalline γ-isotactic polypropylene , 1989, Nature.

[57]  M. Pegoraro,et al.  New additives in glass reinforced polyolefins , 1989 .

[58]  W. Schneider,et al.  Non – Isothermal Crystallization Crystallization of Polymers , 1988 .

[59]  A. J. Lovinger,et al.  Studies on the α and β forms of isotactic polypropylene by crystallization in a temperature gradient , 1977 .

[60]  D. Gray.  ``Transcrystallization'' induced by mechanical stress on a polypropylene melt , 1974 .

[61]  J. Hoffman,et al.  Extension of theory of growth of chain‐folded polymer crystals to large undercoolings , 1973 .

[62]  M. Ueda,et al.  The reaction of polypropylene with maleic anhydride , 1969 .

[63]  J. L. Riley,et al.  Density, crystallinity, and heptane insolubility in isotactic polypropylene , 1959 .

[64]  M. Avrami.  Kinetics of Phase Change. II Transformation‐Time Relations for Random Distribution of Nuclei , 1940 .

[65]  M. Avrami.  Kinetics of Phase Change. I General Theory , 1939 .

[66]  Hua Gao,et al.  Grafting effects of polypropylene/polyethylene blends with maleic anhydride on the properties of the resulting wood–plastic composites , 2012 .

[67]  Bumjae Lee,et al.  Effect of compatibilizing agents on rice-husk flour reinforced polypropylene composites , 2007 .

[68]  A. P. Hammersley,et al.  Two-dimensional detector software: From real detector to idealised image or two-theta scan , 1996 .

[69]  M. Mishra,et al.  Nondegradative reaction of maleic anhydride and molten polypropylene in the presence of peroxides , 1983 .