Analysis of RF MEMS switch packaging Process for yield improvement

Radio frequency microelectro-mechanical systems (RF MEMS) switches offer significant performance advantages in high-frequency RF applications. The switches are actuated by electrostatic force when voltage was applied to the electrodes. Such devices provide high isolation when open and low contact resistance when closed. However, during the packaging process, there are various possible failure modes that may affect the switch yield and performance. The RF MEMS switches were first placed in a package and went through lid seal at 320degC. The assembled packages were then attached to a printed circuit board at 220degC. During the process, some switches failed due to electrical shorting. Interestingly, more failures were observed at the lower temperature of 220degC rather than 320degC. The failure mode was associated with the shorting bar and the cantilever design. Finite element simulations and simplified analytical solutions were used to understand the mechanics driving the behaviors. Simulation results have shown excellent agreement with experimental observations and measurements. Various solutions in package configurations were explored to overcome the hurdles in MEMS packaging and achieve better yield and performance

[1]  Milton Feng,et al.  Reliability Study of Low-Voltage RF MEMS Switches , 2002 .

[2]  S. Eshelman,et al.  Characteristics of micromachined switches at microwave frequencies , 1996, 1996 IEEE MTT-S International Microwave Symposium Digest.

[3]  L.L. Mercado,et al.  Mechanics-based solutions to RF MEMS switch stiction problem , 2004, IEEE Transactions on Components and Packaging Technologies.

[4]  J.A. Higgins,et al.  MEM relay for reconfigurable RF circuits , 2001, IEEE Microwave and Wireless Components Letters.

[5]  L. Vietzorreck.  Modeling of the millimeter-wave behavior of MEMS capacitive switches , 1999, 1999 IEEE MTT-S International Microwave Symposium Digest (Cat. No.99CH36282).

[6]  E. Beyne,et al.  A fully-packaged electromagnetic microrelay , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[7]  S. Shoji,et al.  Anodic bonding below 180/spl deg/C for packaging and assembling of MEMS using lithium aluminosilicate-/spl beta/-quartz glass-ceramic , 1997, Proceedings IEEE The Tenth Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots.

[8]  K. Harsh,et al.  Flip-chip assembly for Si-based RF MEMS , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[9]  Geun-Ho Kim,et al.  Electroplated rf MEMS capacitive switches , 2000, Proceedings IEEE Thirteenth Annual International Conference on Micro Electro Mechanical Systems (Cat. No.00CH36308).

[10]  M. F. Chang,et al.  A Surface Micromachined Miniature Switch For Telecommunications Applications With Signal Frequencies From DC Up To 4 Ghz , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.