Corrosion behavior of steel in alkali-activated fly ash mortars in the light of their microstructural, mechanical and chemical characterization

This study concerns the corrosion behavior of steel in different room temperature cured alkali-activated fly ash mortars exposed to chloride solution. The corrosion process was monitored by polarization resistance and corrosion potential measurements and the results were interpreted in the light of a complete microstructural, mechanical and chemical characterization of the mortars. The most compact alkali-activated mortars have higher porosity and lower mechanical properties than a cement-based mortar (CEM), but the protectiveness afforded to the rebars is slightly higher than that obtained in CEM. The reason for this discrepancy is connected to a lower chloride content accumulated in the former mortar type and to a specific inhibition of the rebar corrosion afforded by the pore electrolyte in alkali-activated mortars.

[1]  Stefano P. Trasatti,et al.  Electrochemical characterization of mild steel in alkaline solutions simulating concrete environment , 2015 .

[2]  C. Andrade,et al.  An Initial Effort to Use the Corrosion Rate Measurements for Estimating Rebar Durability , 1990 .

[3]  Erez N. Allouche,et al.  Corrosion of steel bars induced by accelerated carbonation in low and high calcium fly ash geopolymer concretes , 2014 .

[4]  J. M. Bastidas,et al.  Organic corrosion inhibitor mixtures for reinforcing steel embedded in carbonated alkali-activated fly ash mortar , 2012 .

[5]  Antoine Elimbi,et al.  Utilization of volcanic ashes for the production of geopolymers cured at ambient temperature , 2013 .

[6]  J. Kropp,et al.  Performance criteria for concrete durability : state of the art report prepared by RILEM Technical Committee TC 116-PCD, Performance of Concrete as a Criterion of its Durability , 1995 .

[7]  Iduvirges Lourdes Muller,et al.  Passivation of pure iron in alkaline solution containing silicate and sulphate—Galvanostatic and Potentiostatic studies , 1999 .

[8]  Helmut Yabar,et al.  World cement production and environmental implications , 2014 .

[9]  Jadambaa Temuujin,et al.  Thermal analysis of geopolymer pastes synthesised from five fly ashes of variable composition , 2012 .

[10]  J. Brito,et al.  An overview on concrete carbonation in the context of eco-efficient construction: Evaluation, use of SCMs and/or RAC , 2012 .

[11]  S. Martínez-Ramírez,et al.  Corrosion rate and corrosion product characterisation using Raman spectroscopy for steel embedded in chloride polluted fly ash mortar , 2013 .

[12]  Huajun Zhu,et al.  Durability of alkali-activated fly ash concrete: Chloride penetration in pastes and mortars , 2014 .

[13]  Ángel Palomo,et al.  An XRD Study of the Effect of the SiO2/Na2O Ratio on the Alkali Activation of Fly Ash , 2007 .

[14]  A. Balbo,et al.  Mechanical Performances and Corrosion Resistance of Reinforced Fly Ash Geopolymer Mortars , 2014 .

[15]  Stefania Manzi,et al.  Room temperature alkali activation of fly ash: The effect of Na2O/SiO2 ratio , 2014 .

[16]  Suksun Horpibulsuk,et al.  Strength development in clay–fly ash geopolymer , 2013 .

[18]  T. Bakharev,et al.  Thermal behaviour of geopolymers prepared using class F fly ash and elevated temperature curing , 2006 .

[19]  Adam Neville,et al.  Chloride attack of reinforced concrete: an overview , 1995 .

[20]  Ueli Angst,et al.  Critical Chloride Content in Reinforced Concrete: A Review , 2009 .

[21]  Ángel Palomo,et al.  Corrosion resistance in activated fly ash mortars , 2005 .

[22]  Z. Baščarević,et al.  Mechanical and microstructural properties of alkali-activated fly ash geopolymers. , 2010, Journal of hazardous materials.

[23]  J. Deventer,et al.  The Role of Inorganic Polymer Technology in the Development of ‘Green Concrete’ , 2007 .

[24]  A. Fernández-Jiménez,et al.  A study on the passive state stability of steel embedded in activated fly ash mortars , 2008 .

[25]  H. Lee,et al.  Setting and mechanical properties of alkali-activated fly ash/slag concrete manufactured at room temperature , 2013 .

[26]  Vesa Penttala,et al.  The pH measurement of concrete and smoothing mortar using a concrete powder suspension , 2004 .

[27]  J. M. Bastidas,et al.  Corrosion behaviour of a Low Ni austenitic stainless steel in carbonated chloride-polluted alkali-activated fly ash mortar , 2014 .

[28]  I. L. Muller,et al.  A RRDE study of the electrochemical behavior of iron in solutions containing silicate and sulphate at pH 10–13 , 1999 .

[29]  Fernando Pacheco-Torgal,et al.  Durability of alkali-activated binders: A clear advantage over Portland cement or an unproven issue? , 2012 .

[30]  J. Deventer,et al.  Understanding the relationship between geopolymer composition, microstructure and mechanical properties , 2005 .

[31]  Ángel Palomo,et al.  Composition and Microstructure of Alkali Activated Fly Ash Binder: Effect of the Activator , 2005 .

[32]  J. Davidovits.  Geopolymers : inorganic polymeric new materials , 1991 .

[33]  Bishwajit Bhattacharjee,et al.  Porosity, pore size distribution and in situ strength of concrete , 2003 .

[34]  Stefania Manzi,et al.  Mix-design and characterization of alkali activated materials based on metakaolin and ladle slag , 2013 .

[35]  Kyung-Taek Koh,et al.  The mechanical properties of fly ash-based geopolymer concrete with alkaline activators , 2013 .

[36]  Wichian Chalee,et al.  Effect of sodium hydroxide concentration on chloride penetration and steel corrosion of fly ash-based geopolymer concrete under marine site , 2014 .

[37]  P. Refait,et al.  The mechanisms of oxidation of ferrous hydroxychloride β-Fe2(OH)3Cl in aqueous solution: The formation of akaganeite vs goethite , 1997 .

[38]  J. González,et al.  Estabilidad del estado pasivo del acero en morteros de ceniza volante activada , 2010 .

[39]  J. Deventer,et al.  Geopolymer technology: the current state of the art , 2007 .

[40]  John L. Provis,et al.  Influence of fly ash on the water and chloride permeability of alkali-activated slag mortars and concretes , 2013 .

[41]  P. Svoboda,et al.  Assessment of phase formation in alkali activated low and high calcium fly ashes in building materials , 2010 .