Abstract : This paper describes the unsteady blade surface pressures on the first-stage rotor blades of a two-stage transonic axial flow compressor experiencing inlet flow distortion. This study was conducted to demonstrate the ability of a full annulus unsteady Reynolds-averaged Navier-Stokes numerical technique to predict unsteady pressures on the rotor blades operating in a distorted inflow. A total pressure distortion produced by a variable mesh screen mounted near the inlet was used to excite the unsteady blade loading on the rotor. On-blade pressure transducers were used to measure the unsteady blade surface pressure. These pressures and the resulting transient load on the rotor blades were compared to the numerical prediction. It is important to develop numerical techniques to predict these transient loads to better understand the response of compressor blades to forcing functions. With this enhanced understanding and ability to predict these transient forces, more robust compressors can be developed. In the study, a high definition of the inlet flow distortion was achieved by rotating the distortion screens. In this manner the inlet flow distortion and the distortion at the first stage stator leading edge were measured at approximately every 0.7 degrees. This full annulus high definition of the inlet flow distortion was used as the inlet boundary condition for the numerical technique. The experimental measurements and numerical analyses are highly complementary in this study. Detailed comparisons between the measurements and the numerical analyses indicate that the current numerical procedure calculates the unsteady aerodynamic pressure on the blade surfaces reasonably well. Further, the agreement of the measured and predicted rotor exit flow distortion at the first stage stator leading edge provides verification of the numerical technique.
[1]
C. Hah,et al.
Calculation of three-dimensional viscous flows in turbomachinery with an implicit relaxation method
,
1987
.
[2]
D Rabe,et al.
Influence of inlet distortion on transonic compressor blade loading
,
1995
.
[3]
Chunill Hah,et al.
Characterization of the first-stage rotor in a two-stage transonic compressor
,
1995
.
[4]
Greg Minkiewicz,et al.
Dynamic Response of Low Aspect Ratio Blades in a Two Stage Transonic Compressor
,
1997
.
[5]
Aspi Rustom Wadia,et al.
Structures and Dynamics Committee Best Paper of 1996 Award: Inlet Distortion Generated Forced Response of a Low-Aspect-Ratio Transonic Fan
,
1997
.
[6]
Aspi Rustom Wadia,et al.
Effects of Inlet Distortion on the Flow Field in a Transonic Compressor Rotor
,
1996
.
[8]
Steven L. Puterbaugh,et al.
Unsteady aerodynamic flow phenomena in a transonic compressor stage
,
1993
.
[9]
A. J. Wennerstrom,et al.
Experimental Study of a High-Throughflow Transonic Axial Compressor Stage
,
1984
.
[10]
Wolfgang Rodi,et al.
Calculation of wake-induced unsteady flow in a turbine cascade
,
1992
.