Computational Fluid Dynamics (CFD) Modeling of Swirling Flows in Industrial Counter-Current Spray-Drying Towers under Fouling Conditions

This work presents a novel procedure to predict the airflow pattern under different levels of deposition and Reynolds numbers for swirling-flow industrial-scale spray-drying towers. It improves the accuracy in the prediction of both the hydrodynamics and the effect of the deposition. Initially, steady-state and transient simulations are compared, showing that the model can be reduced to steady state for a certain mesh size. The computational fluid dynamics (CFD) model is later calibrated using the experimental swirl intensity values under different levels of deposits that have reached a dynamic equilibrium. The model then is validated for different Reynolds numbers of operation. Finally, the validated model is applied to examine the vortex behavior and evaluate the effect of the tower radius reduction. A limit of operation is found for low Reynolds numbers, in terms of stability, and it is observed that the momentum cannot be only modeled with the radius reduction.

[1]  F. Durst,et al.  Turbulence measurements in a swirling pipe flow , 2006 .

[2]  Ireneusz Zbicinski,et al.  Modeling of Air Flow in an Industrial Countercurrent Spray-Drying Tower , 2012 .

[3]  Residence time distribution of glass ballotini in isothermal swirling flows in a counter-current spray drying tower , 2017 .

[4]  M. Simmons,et al.  An experimental investigation of the swirling flow in a tall-form counter current spray dryer , 2015 .

[5]  A. F. Najafi,et al.  Numerical investigations on swirl intensity decay rate for turbulent swirling flow in a fixed pipe , 2011 .

[6]  Tao Wu,et al.  Improving the efficiency of 'Clean-In-Place' procedures using a four-lobed swirl pipe: A numerical investigation , 2015 .

[7]  D. Evin,et al.  Heat transfer enhancement in circular tubes using helical swirl generator insert at the entrance , 2007 .

[8]  A. Mujumdar,et al.  Non-Swirling Steady and Transient Flow Simulations in Short-Form Spray Dryers , 2009 .

[9]  Mohammad Hassan Saidi,et al.  Numerical analysis of turbulent swirling decay pipe flow , 2005 .

[10]  T. Langrish,et al.  The Effect of Swirl on Flow Stability in Spray Dryers , 2001 .

[11]  Jos Derksen,et al.  Simulation of vortex core precession in a reverse‐flow cyclone , 2000 .

[12]  Adrian J. Saul,et al.  Improving Water Quality Using Hydrodynamic Vortex Separators and Screening Systems , 2002 .

[13]  N. Syred.  A review of oscillation mechanisms and the role of the precessing vortex core (PVC) in swirl combustion systems , 2006 .

[14]  M. Simmons,et al.  The role of wall deposition and re-entrainment in swirl spray dryers , 2015 .

[15]  Ian Lowndes,et al.  An experimental investigation of pneumatic swirl flow induced by a three lobed helical pipe , 2009 .

[16]  P. Roache.  Perspective: A Method for Uniform Reporting of Grid Refinement Studies , 1994 .

[17]  David F. Fletcher,et al.  A Computational Fluid Dynamics Study of a Tall-Form Spray Dryer , 2002 .

[18]  F. Lien,et al.  Assessment of turbulence-transport models including non-linear rng eddy-viscosity formulation and second-moment closure for flow over a backward-facing step , 1994 .

[19]  F. Carlsson,et al.  Large eddy simulation of unsteady turbulent flow in a semi-industrial size spray dryer , 2013 .

[20]  M. Simmons,et al.  Influence of wall friction on flow regimes and scale-up of counter-current swirl spray dryers , 2015 .

[21]  J. Williams,et al.  Simulation of the Effects of Inlet Swirl on Gas Flow Patterns in a Pilot-Scale Spray Dryer , 2004 .

[22]  R. Maddahian,et al.  Analytical investigation of boundary layer growth and swirl intensity decay rate in a pipe , 2011 .

[23]  H. Foroutan,et al.  A partially-averaged Navier–Stokes model for the simulation of turbulent swirling flow with vortex breakdown , 2014 .

[24]  R. Antonia,et al.  Influence of localised wall suction on the anisotropy of the Reynolds stress tensor in a turbulent boundary layer , 2004 .

[25]  S. Leibovich.  THE STRUCTURE OF VORTEX BREAKDOWN , 1978 .

[26]  W. Ranz,et al.  Backflows in rotating fluids moving axially through expanding cross sections , 1964 .

[27]  M. Darwish,et al.  The Finite Volume Method in Computational Fluid Dynamics: An Advanced Introduction with OpenFOAM® and Matlab , 2015 .

[28]  M. P. Escudier,et al.  Recirculation in swirling flow - A manifestation of vortex breakdown , 1985 .