Analysis of Electrothermal Effects in Devices and Arrays in InGaP/GaAs HBT Technology

In this paper, the dc electrothermal behavior of InGaP/GaAs HBT test devices and arrays for power amplifier output stages is extensively analyzed through an efficient simulation approach. The approach relies on a full circuit representation of the domains, which accounts for electrothermal effects through the thermal equivalent of the Ohm’s law and can be solved in any commercial circuit simulator. In particular, the power-temperature feedback is described through an equivalent thermal network automatically obtained by (i) generating a realistic 3-D geometry/mesh of the domain in the environment of a numerical tool with the aid of an in-house routine; (ii) feeding the geometry/mesh to FANTASTIC, which extracts the network without performing simulations. Nonlinear thermal effects adversely affecting the behavior of devices/arrays at high temperatures are included through a calibrated Kirchhoff’s transformation. For the test devices, the thermally-induced distortion in I–V curves is explained, and the limits of the safe operating regions are identified for a wide range of bias conditions. A deep insight into the electrothermal behavior of the arrays is then provided, with particular emphasis on the detrimental nonuniform operation. Useful guidelines are offered to designers in terms of layout and choice of the ballasting strategy.

[1]  Paolo Maffezzoni,et al.  Compact modeling of electrical devices for electrothermal analysis , 2003 .

[2]  V. d'Alessandro,et al.  Analysis of the Bipolar Current Mirror Including Electrothermal and Avalanche Effects , 2009, IEEE Transactions on Electron Devices.

[3]  V. d’Alessandro,et al.  Circuit-Based Electrothermal Simulation of Multicellular SiC Power MOSFETs Using FANTASTIC , 2020 .

[4]  S. L. Miller.  Ionization Rates for Holes and Electrons in Silicon , 1957 .

[5]  A. Gupta,et al.  CW measurement of HBT thermal resistance , 1992 .

[6]  V. d’Alessandro,et al.  Thermal Design of Multifinger Bipolar Transistors , 2010, IEEE Transactions on Electron Devices.

[7]  Krzysztof Górecki,et al.  Modelling dynamic characteristics of the IGBT with thermal phenomena taken into account , 2017 .

[8]  Vincenzo d'Alessandro,et al.  Influence of Scaling and Emitter Layout on the Thermal Behavior of Toward-THz SiGe:C HBTs , 2014, IEEE Transactions on Electron Devices.

[9]  V. d'Alessandro,et al.  Theory of electrothermal behavior of bipolar transistors: part III-impact ionization , 2006, IEEE Transactions on Electron Devices.

[10]  V. d’Alessandro,et al.  Analysis of Electrothermal and Impact-Ionization Effects in Bipolar Cascode Amplifiers , 2018, IEEE Transactions on Electron Devices.

[11]  W. B. Joyce,et al.  Thermal resistance of heat sinks with temperature-dependent conductivity , 1975 .

[12]  J. Sitch,et al.  A new large signal HBT model , 1994 .

[13]  Wen-Chau Liu,et al.  The collapse of current gain in multi-finger heterojunction bipolar transistors: its substrate temperature dependence, instability criteria, and modeling , 1994 .

[14]  V. d’Alessandro,et al.  Analysis of Electrothermal Effects in Bipolar Differential Pairs , 2011, IEEE Transactions on Electron Devices.

[15]  B. Li,et al.  Nonlinear Transistor Model Parameter Extraction Techniques: Practical statistical simulation for efficient circuit design , 2011 .

[16]  P.M. Asbeck,et al.  Heating effects on the accuracy of HBT voltage comparators , 1987, IEEE Transactions on Electron Devices.

[17]  Janusz Zarebski,et al.  The Electrothermal Large-Signal Model of Power MOS Transistors for SPICE , 2010, IEEE Transactions on Power Electronics.

[18]  Alessandro Magnani,et al.  Simulation comparison of InGaP/GaAs HBT thermal performance in wire-bonding and flip-chip technologies , 2017, Microelectron. Reliab..

[19]  Wen-Chau Liu,et al.  Thermal coupling in 2-finger heterojunction bipolar transistors , 1995 .

[20]  Mau-Chung Frank Chang,et al.  Thermal design and simulation of bipolar integrated circuits , 1992 .

[21]  Vincenzo d'Alessandro,et al.  Evaluation of thermal balancing techniques in InGaP/GaAs HBT power arrays for wireless handset power amplifiers , 2013, Microelectron. Reliab..

[22]  V. d'Alessandro,et al.  Restabilizing mechanisms after the onset of thermal instability in bipolar transistors , 2006, IEEE Transactions on Electron Devices.

[23]  S. Nelson,et al.  Current gain collapse in microwave multifinger heterojunction bipolar transistors operated at very high power densities , 1993 .

[24]  R. Anholt,et al.  HBT thermal element design using an electro/thermal simulator , 1998 .

[25]  Lorenzo Codecasa,et al.  Accurate and efficient analysis of the upward heat flow in InGaP/GaAs HBTs through an automated FEM‐based tool and Design of Experiments , 2018, International Journal of Numerical Modelling: Electronic Networks, Devices and Fields.

[26]  C. Popescu.  Selfheating and thermal runaway phenomena in semiconductor devices , 1970 .

[27]  V. d'Alessandro,et al.  Influence of Concurrent Electrothermal and Avalanche Effects on the Safe Operating Area of Multifinger Bipolar Transistors , 2009, IEEE Transactions on Electron Devices.

[28]  Lorenzo Codecasa,et al.  A Priori Error Bound for Moment Matching Approximants of Thermal Models , 2019, IEEE Transactions on Components, Packaging and Manufacturing Technology.

[29]  P. R. Bryant,et al.  Multiple equilibrium points and their significance in the second breakdown of bipolar transistors , 1981 .

[30]  W. Liu,et al.  The use of base ballasting to prevent the collapse of current gain in AlGaAs/GaAs heterojunction bipolar transistors , 1996 .

[31]  V. d'Alessandro,et al.  A back-wafer contacted silicon-on-glass integrated bipolar process. Part II. A novel analysis of thermal breakdown , 2004, IEEE Transactions on Electron Devices.