Modeling and optimization of hollow fiber DCMD module for desalination

To maximize the desalination performance of both productivity and thermal efficiency, model-based optimal design of a hollow fiber direct contact membrane distillation (DCMD) module is proposed. The mathematical model equations for the entire module are derived by integrating the permeate flux across the membrane with the mass, momentum and energy balances on both feed and permeate sides. The property variations of feed and permeate sides along the length of the membrane module are simulated. It is found that there is a trade-off between the permeate flux (productivity) and thermal efficiency. The trade-off depends on not only the operating variables, such as the temperature and the flow rate of the cold solution, but also the fiber dimensions, such as the fiber length and the packing density. Based on the above decision variables, optimization of the hollow fiber DCMD module is carried out using the Pareto genetic algorithm. It is demonstrated that the optimal values of the inlet cold flow rate and the fiber length are more sensitive than the module packing density. With the synchronous increase in the inlet cold flow rate and the fiber length, the productivity increases at the cost of higher thermal efficiency.

[1]  Anthony G. Fane,et al.  A new model for mass transfer in direct contact membrane distillation , 2003 .

[2]  Minh H. Nguyen,et al.  Shell-side mass transfer of hollow fibre modules in osmotic distillation process , 2007 .

[3]  Mohamed Khayet,et al.  A framework for better understanding membrane distillation separation process , 2006 .

[4]  Anthony G. Fane,et al.  Mass transfer mechanisms and transport resistances in direct contact membrane distillation process , 2006 .

[5]  Jack Gilron,et al.  Direct Contact Membrane Distillation-Based Desalination: Novel Membranes, Devices, Larger-Scale Studies, and a Model , 2007 .

[6]  M. Khayet,et al.  Heat and mass transfer in vacuum membrane distillation , 2004 .

[7]  Marek Gryta,et al.  Heat transport in the membrane distillation process , 1998 .

[8]  Eva Sorensen,et al.  A general approach to modelling membrane modules , 2003 .

[9]  Siegfried Ripperger,et al.  Membranes and modules for transmembrane distillation , 1988 .

[10]  Anthony G. Fane,et al.  Heat transport and membrane distillation coefficients in direct contact membrane distillation , 2003 .

[11]  Ajay K. Ray,et al.  Multi-objective optimization of membrane separation modules using genetic algorithm , 2000 .

[12]  Anthony G. Fane,et al.  Gas and vapour transport through microporous membranes. II. Membrane distillation , 1990 .

[13]  Noam Lior,et al.  Heat and mass transfer resistance analysis of membrane distillation , 2006 .

[14]  S. P. Agashichev,et al.  Modeling and calculation of temperature-concentration polarisation in the membrane distillation process (MD) , 1993 .

[15]  Nazish Hoda,et al.  Pervaporation of hydrazine-water through hollow fiber module: Modeling and simulation , 2005, Comput. Chem. Eng..

[16]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[17]  K. Sirkar,et al.  Novel membrane and device for direct contact membrane distillation-based desalination process , 2004 .

[18]  Enrico Drioli,et al.  Direct contact membrane distillation: modelling and concentration experiments , 2000 .