Refrigerant flow boiling heat transfer in parallel microchannels as a function of local vapor quality

Abstract Flow boiling of refrigerant HFC-134a in a multi-microchannel copper cold plate evaporator is investigated. The heat transfer coefficient is measured locally for the entire range of vapor qualities starting from subcooled liquid to superheated vapor. The test piece contains 17 parallel, rectangular microchannels (0.762 mm wide) of hydraulic diameter 1.09 mm and aspect ratio 2.5. The design of the test facility is validated by a robust energy balance as well as a comparison of single-phase heat transfer coefficients with results from the literature. Results are presented for four different mass fluxes of 20.3, 40.5, 60.8, and 81.0 kg m−2 s−1, which correspond to refrigerant mass flow rates of 0.5–2.0 g s−1, and at three different pressures 400, 550 and 750 kPa corresponding to saturation temperatures of 8.9, 18.7, and 29 °C. The wall heat flux varies from 0 to 20 W/cm2 in the experiments. The heat transfer coefficient is found to vary significantly with refrigerant inlet quality and mass flow rate, but only slightly with saturation pressure for the range of values investigated. The peak heat transfer coefficient is observed for a vapor quality of approximately 20%.

[1]  M. W. Wambsganss,et al.  Small circular- and rectangular-channel boiling with two refrigerants , 1996 .

[2]  A. Mosyak,et al.  CONVECTIVE BOILING IN PARALLEL MICROCHANNELS , 2004, Proceeding of Advances in Heat Transfer Engineering.

[3]  S. Garimella,et al.  Saturated flow boiling heat transfer and pressure drop in silicon microchannel arrays , 2008 .

[4]  J. Thome,et al.  Investigation of Flow Boiling in Horizontal Tubes: Part II, Development of a New Heat Transfer Model for Stratified-Wavy, Dryout and Mist Flow Regimes , 2005 .

[5]  Shizuo Saitoh,et al.  Effect of tube diameter on boiling heat transfer of R-134a in horizontal small-diameter tubes , 2005 .

[6]  Tsing-Fa Lin,et al.  Evaporation heat transfer and pressure drop of refrigerant R-134a in a small pipe , 1998 .

[7]  S. Churchill.  A comprehensive correlating equation for laminar, assisting, forced and free convection , 1977 .

[8]  T. Lin,et al.  Subcooled flow boiling heat transfer and associated bubble characteristics of R-134 a in a narrow annular duct , 2006 .

[9]  Lounes Tadrist,et al.  Review on two-phase flow instabilities in narrow spaces , 2007 .

[10]  H. Lee,et al.  Heat transfer correlation for boiling flows in small rectangular horizontal channels with low aspect ratios , 2001 .

[11]  S. Garimella,et al.  TRANSPORT IN MICROCHANNELS - A CRITICAL REVIEW , 2003 .

[12]  S. Lin,et al.  Two-Phase evaporation of a refrigerant in a 1mm diameter tube , 2001 .

[13]  S. Lin,et al.  Two-phase heat transfer to a refrigerant in a 1 mm diameter tube , 2001 .

[14]  Nobuhide Kasagi,et al.  Visualization of convective boiling heat transfer in single microchannels with different shaped cross-sections , 2006 .

[15]  I. Mudawar,et al.  Two-phase flow in high-heat-flux micro-channel heat sink for refrigeration cooling applications: Part II—heat transfer characteristics , 2005 .

[16]  Y. Lie,et al.  Saturated flow boiling heat transfer and associated bubble characteristics of R-134a in a narrow annular duct , 2005 .

[17]  Huiying Wu,et al.  Visualization and measurements of periodic boiling in silicon microchannels , 2003 .

[18]  E. N. Sieder,et al.  Heat Transfer and Pressure Drop of Liquids in Tubes , 1936 .

[19]  M. Mochizuki,et al.  Small scale refrigeration system for electronics cooling within a notebook computer , 2006, Thermal and Thermomechanical Proceedings 10th Intersociety Conference on Phenomena in Electronics Systems, 2006. ITHERM 2006..

[20]  Dong Liu,et al.  On-Chip Thermal Management With Microchannel Heat Sinks and Integrated Micropumps , 2006, Proceedings of the IEEE.

[21]  M. Molki,et al.  Visualization and Modeling of Flow Boiling of R-134A in Minichannels with Transverse Ribs , 2004 .

[22]  Avram Bar-Cohen,et al.  Modeling and Prediction of Two-Phase Refrigerant Flow Regimes and Heat Transfer Characteristics in Microgap Channels , 2007 .

[23]  G. M. Lazarek,et al.  Evaporative heat transfer, pressure drop and critical heat flux in a small vertical tube with R-113 , 1982 .

[24]  S. Garimella,et al.  Measurements and High-Speed Visualizations of Flow Boiling of a Dielectric Fluid in a Silicon Microchannel Heat Sink † , 2006 .

[25]  Issam Mudawar,et al.  Transport Phenomena in Two-Phase Micro-Channel Heat Sinks , 2004 .

[26]  R. Pease,et al.  High-performance heat sinking for VLSI , 1981, IEEE Electron Device Letters.

[27]  Mark E. Steinke,et al.  Flow Boiling and Pressure Drop in Parallel Flow Microchannels , 2003 .

[28]  I. Mudawar,et al.  Two-phase flow in high-heat-flux microchannel heat sink for refrigeration cooling applications : Part I – – pressure drop characteristics , 2005 .

[29]  J. Thome.  Boiling in microchannels: a review of experiment and theory , 2004 .

[30]  Ali Koşar,et al.  Hydrodynamic Cavitation and Boiling in Refrigerant (R-123) Flow Inside Microchannels , 2007 .

[31]  S. Garimella,et al.  Investigation of heat transfer in rectangular microchannels , 2005 .

[32]  S. Garimella,et al.  Prediction of the onset of nucleate boiling in microchannel flow , 2005 .

[33]  S. Kandlikar,et al.  An Experimental Investigation of Flow Boiling Characteristics of Water in Parallel Microchannels , 2004 .

[34]  C. Pan,et al.  Two-phase flow instability for boiling in a microchannel heat sink , 2007 .

[35]  S. Garimella,et al.  Flow boiling heat transfer in microchannels , 2007 .

[36]  R. Yun,et al.  Evaporative heat transfer and pressure drop of R410A in microchannels , 2006 .

[37]  J. Taylor.  An Introduction to Error Analysis , 1982 .

[38]  S.V. Garimella,et al.  Experimental Investigation of a Miniature-Scale Refrigeration System for Electronics Cooling , 2006, IEEE Transactions on Components and Packaging Technologies.

[39]  J. Swanson,et al.  Designing a mesoscale vapor-compression refrigerator for cooling high-power microelectronics , 2004, The Ninth Intersociety Conference on Thermal and Thermomechanical Phenomena In Electronic Systems (IEEE Cat. No.04CH37543).

[40]  John R. Thome,et al.  Heat Transfer Model for Evaporation in Microchannels, Part II: Comparison with the Database , 2004 .