Abstract Micro gas turbine applications in concentrating solar field systems is already on industrial stage. The peculiarity of these systems is the possibility to use fossil fuels when solar power source is lacking. It is preferable that the system works in solar-only mode for long time; however, owing to the efficiency loss which occur for low radiation levels, a fuel integration is necessary. This work presents a system which allows to operate with constant efficiency, without the use of fuel for over one fifth of the nominal power rate. It is based on a regenerated micro gas turbine in closed loop configuration. The proposed system includes the solar tower, the heliostats field, the regenerator and a low temperature heat exchanger which cools the working fluid. Finally, two more devices, for the actuation of the proposed control are included: an auxiliary compressor and a bleed valve. The use of air as working fluid has been analyzed, with different values of the base cycle pressure (inlet pressure of the main compressor), which are needed for varying the mass flow flowing in the system. The control of the mass flow rate is mandatory to regulate the gas turbine power, by keeping almost constant the maximum temperature of the thermodynamic cycle when the incident solar radiation changes. In particular, the auxiliary compressor admits fresh air in the cycle when the thermal power received by the sun increases, while the bleed valve discharges it in the atmosphere, when the thermal power decreases. Therefore, the thermodynamic cycle is unchanged and guarantees constant net system efficiency for all the operations conditions. Particular attention is given to the receiver thermal incident flux, heliostat field and solar tower design. The current results are compared with the annual efficiency and energy production of an existing plant in hybrid configuration (solar-fuel).The analysis has been carried out on a commercial gas turbine having a power of 100 kW, sited on Seville town. For the heliostat field analysis, the open source code Solar PILOT has been used, while for the entire plant the code Thermoflex has been employed.
[1]
Davide Astiaso Garcia,et al.
Energy Contribution of OFMSW (Organic Fraction of Municipal Solid Waste) to Energy-Environmental Sustainability in Urban Areas at Small Scale
,
2017
.
[2]
Thorsten Denk,et al.
Test and evaluation of a solar powered gas turbine system
,
2006
.
[3]
Gianluigi Lo Basso,et al.
How to handle the Hydrogen enriched Natural Gas blends in combustion efficiency measurement procedure of conventional and condensing boilers
,
2017
.
[4]
Gianluigi Lo Basso,et al.
Single Cylinder Internal Combustion Engine Fuelled with H2NG Operating as Micro-CHP for Residential Use: Preliminary Experimental Analysis on Energy Performances and Numerical Simulations for LCOE Assessment
,
2015
.
[5]
Vittorio Ferraro,et al.
On the performance of CSP oil-cooled plants, with and without heat storage in tanks of molten salts
,
2015
.
[6]
Marco J. Castaldi,et al.
Simulation of CO2 storage and methane gas production from gas hydrates in a large scale laboratory reactor
,
2016
.
[7]
I. Lillo-Bravo,et al.
Solar resource assessment in Seville, Spain. Statistical characterisation of solar radiation at different time resolutions
,
2016
.
[8]
Miriam Ebert,et al.
Solugas – Operation Experience of the First Solar Hybrid Gas Turbine System at MW Scale
,
2014
.
[9]
Patrizia Beraldi,et al.
Optimization of Heliostat Field in a Thermal Solar Power Plant with an Unfired Closed Joule-Brayton Cycle
,
2016
.
[10]
Mario Amelio,et al.
Analysis of a Concentrating Solar Power Tower Operating with a Closed Joule Brayton Cycle and Thermal Storage
,
2016
.