Thermal Stresses Analysis of a Circular Tube in a Central Receiver

Abstract The tubes of central receiver power plants are designed to work under very demanding conditions, with heat fluxes varying between 0.2 to 1 MW/m2, depending on both the weather conditions and the operating regime of the plant. Also, the heat flux is localized along the circumferential coordinate of the tube, on the outward facing side of the tube. This results in a non-uniform temperature distribution with strong gradients both in the heat transfer fluid and the pipe walls. Predicting this distribution is important since it can induce high thermal stresses on the pipe walls and it is a key factor for the fluid decomposition. In this work we have studied different configurations to analyze the effects of tube diameter and wall thickness in the temperature distributions in the fluid and solid, for a typical concentrated solar heat flux distribution. HITEC salt and 316L stainless steel have been used as the heat transfer fluid and the material of the tubes in the receiver, respectively. A numerical method has been used to calculate the temperature distribution of the fluid and the convection coefficient along the circumference. Finally the Von-Mises thermal stresses of the tube receiver have been calculated.

[1]  Jesús M. Lata,et al.  High Flux Central Receivers of Molten Salts for the New Generation of Commercial Stand-Alone Solar Power Plants , 2008 .

[2]  L. Trefethen.  Spectral Methods in MATLAB , 2000 .

[3]  W. C. Reynolds,et al.  Turbulent heat transfer in a circular tube with variable circumferential heat flux , 1963 .

[4]  Sandia Report,et al.  An Evaluation of Possible Next-Generation High-Temperature Molten-Salt Power Towers , 2011 .

[5]  Lu Jianfeng,et al.  Heat transfer performance of an external receiver pipe under unilateral concentrated solar radiation , 2010 .

[6]  R. Quirk,et al.  Measurements of the radial and tangential eddy diffusivities of heat and mass in turbulent flow in a plain tube , 1972 .

[7]  K. Johannsen,et al.  Turbulent heat transfer in a circular tube with circumferentially varying thermal boundary conditions , 1974 .

[8]  J. H. Faupel,et al.  Engineering design: A synthesis of stress analysis and materials engineering , 1981 .

[9]  M. Piller,et al.  Direct numerical simulation of turbulent forced convection in a pipe , 2005 .

[10]  DNS of passive scalar transport in turbulent channel flow at high Schmidt numbers , 2007 .

[11]  María de los Reyes Rodríguez Sánchez,et al.  Thermal, mechanical and hydrodynamic analysis to optimize the design of molten salt central receivers of solar tower power plants , 2013 .

[12]  Xiaoxi Yang,et al.  Numerical simulation study on the heat transfer characteristics of the tube receiver of the solar thermal power tower , 2012 .