论文信息 - Comparison of different methods for earth fault location in compensated networks

Comparison of different methods for earth fault location in compensated networks

The first part of this paper contains a short review on single phase to earth fault location methods in compensated networks. After that a new fault location method is presented that has been implemented recently at Hungarian DSOs. This technique uses current injection parallel to the Petersen coil, and the same device is further used to decrease the harmonics in the residual fault current during sustained earth-fault operation. First field test results are also shown.

Andras Dan | David Raisz

[1] Andras Dan,et al. Fault Location and Compensation of the Harmonic Content of the Residual Fault Current during Single-Phase to Ground Faults in Compensated Networks , 2010 .

[2] C. Obkircher,et al. An earth fault distance location algorithm in compensated networks with additional estimation of the fault impedance and fault current , 2008, 2008 Power Quality and Supply Reliability Conference.

[3] D. Raisz,et al. Comparison of different methods to decrease the harmonic content of the fault current during single-phase to ground faults in compensated networks , 2005, 2005 IEEE Russia Power Tech.

[4] R. Schmidt,et al. Residual current compensation (RCC) for resonant grounded transmission systems using high performance voltage source inverter , 2003, 2003 IEEE PES Transmission and Distribution Conference and Exposition (IEEE Cat. No.03CH37495).

[5] D. Raisz,et al. Decreasing the harmonic content of the fault current during single-phase to ground faults in compensated network , 2009, 2009 IEEE Bucharest PowerTech.