Performance evaluation of a PV (photovoltaic) module by back surface water cooling for hot climatic conditions

The performance of PV (photovoltaic) module is strongly dependent on its operating temperature. Most of the energy absorbed by the panel is converted to heat which is normally lost and provides no value. In order to study the performance of a hybrid PV water cooled system, a numerical model (electrical and thermal) is developed using EES (Engineering Equation Solver) software. The model predicts various electrical and thermal parameters affecting its performance. The effect of cooling the module by incorporating a heat exchanger (cooling panel) at its rear surface is also investigated experimentally. The results of the numerical model are found in good agreement with the experimental measurements performed for the climate of Dhahran, Saudi Arabia. With active water cooling, the module temperature dropped significantly to about 20% leading to an increase in the PV panel efficiency by 9%.

[1]  Jie Ji,et al.  A sensitivity study of a hybrid photovoltaic/thermal water-heating system with natural circulation , 2007 .

[2]  Reza Hosseini,et al.  An Experimental Study of Combining a Photovoltaic System with a Heating System , 2011 .

[3]  Masud Behnia,et al.  Improving Photovoltaic Module Efficiency Using Water Cooling , 2009 .

[4]  K. F. Fong,et al.  Energy and exergy analysis of photovoltaic-thermal collector with and without glass cover , 2009 .

[5]  Yutaka Nawata,et al.  Performance Evaluation of Photovoltaic Power-Generation System Equipped With a Cooling Device Utilizing Siphonage , 2006 .

[6]  Earle A. Wilson.  Theoretical and operational thermal performance of a ‘wet’ crystalline silicon PV module under Jamaican conditions , 2009 .

[7]  Peter Lund,et al.  Exploring past energy changes and their implications for the pace of penetration of new energy technologies , 2010 .

[8]  William A. Beckman,et al.  Improvement and validation of a model for photovoltaic array performance , 2006 .

[9]  Paolo Rosa-Clot,et al.  Optical and thermal behavior of submerged photovoltaic solar panel: SP2 , 2012 .

[10]  Y. Tripanagnostopoulos,et al.  Hybrid photovoltaic/thermal solar systems , 2002 .

[11]  Mustafa İlkan,et al.  An experimental study on energy generation with a photovoltaic (PV)-solar thermal hybrid system , 2008 .

[12]  M. Rosa-Clot,et al.  Submerged photovoltaic solar panel: SP2 , 2010 .

[13]  A. Tiwari,et al.  Performance evaluation of hybrid PV/thermal water/air heating system: A parametric study , 2006 .

[14]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[15]  Said Farahat,et al.  An improved thermal and electrical model for a solar photovoltaic thermal (PV/T) air collector , 2010 .

[16]  Azadeh Kordzadeh,et al.  The effects of nominal power of array and system head on the operation of photovoltaic water pumping set with array surface covered by a film of water , 2010 .

[17]  Karima E. Amori,et al.  Analysis of thermal and electrical performance of a hybrid (PV/T) air based solar collector for Iraq , 2012 .

[18]  Ji Jie,et al.  Performance study and parametric analysis of a novel heat pipe PV/T system , 2012 .

[19]  S. Krauter.  Increased electrical yield via water flow over the front of photovoltaic panels , 2004 .

[20]  Marco Raugei,et al.  Life cycle impacts and costs of photovoltaic systems: Current state of the art and future outlooks , 2009 .

[21]  Arvind Tiwari,et al.  Performance evaluation of solar PV/T system: An experimental validation , 2006 .

[22]  Morteza Abdolzadeh,et al.  Improving the effectiveness of a photovoltaic water pumping system by spraying water over the front of photovoltaic cells , 2009 .

[23]  J. K. Kaldellis,et al.  Quantifying the decrease of the photovoltaic panels energy yield due to phenomena of natural air po , 2010 .