Alternative pre-analytic sample handling techniques for glucose measurement in the absence of fluoride tubes in low resource settings

Introduction Sodium fluoride (NaF) tubes are the recommended tubes for glucose measurements, but these are expensive, have limited number of uses, and are not always available in low resource settings. Alternative sample handling techniques are thus needed. We compared glucose stability in samples collected in various tubes exposed to different pre-analytical conditions in Uganda. Methods Random (non-fasted) blood samples were drawn from nine healthy participants into NaF, Ethylenediaminetetraacetic acid (EDTA), and plain serum tubes. The samples were kept un-centrifuged or centrifuged with plasma or serum pipetted into aliquots, placed in cool box with ice or at room temperature and were stored in a permanent freezer after 0, 2, 6, 12 and 24 hours post blood draw before glucose analysis. Results Rapid decline in glucose concentrations was observed when compared to baseline in serum (declined to 64%) and EDTA-plasma (declined to 77%) after 6 hours when samples were un-centrifuged at room temperature whilst NaF-plasma was stable after 24 hours in the same condition. Un-centrifuged EDTA-plasma kept on ice was stable for up to 6 hours but serum was not stable (degraded to 92%) in the same conditions. Early centrifugation prevented glucose decline even at room temperature regardless of the primary tube used with serum, EDTA-plasma and NaF-plasma after 24 hours. Conclusion In low resource settings we recommend use of EDTA tubes placed in cool box with ice and analysed within 6 hours as an alternative to NaF tubes. Alternatively, immediate separation of blood with manual hand centrifuges will allow any tube to be used even in remote settings with no electricity.