The rapid load testing of piles in fine grained soils.

The behaviour has been examined of piles installed in clay subject to a rapid load testing method known as the Statnamic test. The Statnamic method is easier and quicker to mobilise than a static test and is less complex to analyse than dynamic pile load tests. This investigation consisted of a laboratory study of the effect of the rate of loading on pile behaviour in clay and a field test of a pile in glacial clay to calibrate the findings of the laboratory study. The effects of penetration rate and Statnamic loading on model pile behaviour have been studied using an instrumented clay calibration chamber. The effect of rate of loading on the pile's capacity was quantified using constant rate of penetration tests (CRP) at different pile penetration rates. This allowed viscous soil damping characteristics to be determined and a new Statnamic analysis method incorporating rate dependant soil behaviour to be developed. This rate dependant behaviour can be represented by modification of a non-linear rate law proposed by Randolph & Deeks (1992). A field pile testing facility was developed in glacial till. To test the success of the new Statnamic analysis, a class A prediction of static pile behaviour from prototype pile load testing was undertaken. Encouraging results were obtained for the prediction of ultimate static pile behaviour, but the analysis method under predicted soil-pile stiffness. A soil inertial component was added to the analysis, based upon instrumentation readings, which improved the predicted static soil-pile stiffness. Results from prototype pile testing show that the stiffness during Statnamic and static load tests was very similar up to 50% of the ultimate static pile capacity. Thus, rapid load testing may be used for verification of pile settlements at working loads in clays. At the present level of understanding of testing in clays, rapid load pile tests should not be carried out in isolation. Ideally, tests should be used in conjunction with a static test that will allow back figured parameters to be derived for analysis.

[1]  George D. Bouckovalas,et al.  Approximate non-linear dynamic axial response of piles , 1998 .

[2]  Alec Westley Skempton,et al.  Residual strength of clays in landslides, folded strata and the laboratory , 1985 .

[3]  E. Cruceanu,et al.  Preparation of Homogeneous HgTe ‐ ZnTe Alloys , 1966 .

[4]  W.M.G. Courage,et al.  Application of the stress wave method to automatic signal matching and to statnamic predictions , 1998 .

[5]  W F Anderson.  THE USE OF MULTI-STAGE TRIAXIAL TESTS TO FIND THE UNDRAINED STRENGTH PARAMETERS OF STONY BOULDER CLAY , 1974 .

[6]  Sakuro Murayama,et al.  Flow and Stress Relaxation of Clays , 1966 .

[7]  Alain Holeyman.  Modelling of Pile Dynamic Behavior at the Pile Base during Driving , 1988 .

[8]  E. A. Dickin,et al.  The Influence of Rate of Loading on the Behaviour of Continuous-Flight-Auger Bored Piles in Soft Clay , 2000 .

[9]  Bernadete Ragoni Danziger,et al.  Back analysis of offshore pile driving with an improved soil model , 1999 .

[10]  P. W. Rowe,et al.  A New Consolidation Cell , 1966 .

[11]  Pc Knodel,et al.  Frequency Response of Diaphragm Pore Pressure Transducers in Dynamic Centrifuge Model Tests , 1990 .

[12]  Mark Randolph,et al.  Centrifuge modelling of pipe piles in sand under axial loads , 1999 .

[13]  T Whitaker,et al.  AN INVESTIGATION OF THE SHAFT AND BASE RESISTANCE OF LARGE BORED PILES IN LONDON CLAY , 1966 .

[14]  Alain Holeyman,et al.  Results of dynamic and kinetic pile load tests and outcome of an international prediction event , 2001 .

[15]  Rw Cooke,et al.  Influence of Residual Installation Forces on the Stress Transfer and Settlement Underworking Loads of Jacked and Bored Piles in Cohesive Soils , 1979 .

[16]  Colin A. Whiteman.  Engineering in Glacial Tills. N.A. Trenter (Ed.); CIRIA (Construction Industry Research and Information Association) Report C504, London, 1999, 259pp., £74.00 (CIRIA members); £148.00 (Non-members), ISBN 0 86017 504 9. , 2001 .

[17]  W F Anderson,et al.  A CLAY CALIBRATION CHAMBER FOR TESTING FIELD DEVICES , 1991 .

[18]  Garland Likins,et al.  Dynamic Determination of Pile Capacity , 1985 .

[19]  E.A.L. Smith,et al.  Pile-Driving Analysis by the Wave Equation , 1960 .

[20]  T. W. Lambe,et al.  Predictions in soil engineering , 1973 .

[21]  Bolton,et al.  Empirical pile design based on cone penetrometer data: an explanation for the reduction of unit base resistance between CPTs and piles , 2001 .

[22]  Mark Randolph,et al.  Dynamic and static soil models for axial pile response dynamics , 1992 .