Finite element modelling of machining of AISI 316 steel: Numerical simulation and experimental validation

Abstract The objective of this research is to modeling the thermo mechanical behavior when machining a stainless steel (AISI 316) and to determine the influence of the friction coefficient in the tool-chip interface on cutting and feed forces, cutting temperature, plastic strain, plastic strain rate, maximum shear stress and residual stresses. An experimental validation of the cutting process was conducted in order to verify the numerical simulated results and the comparison shows that the friction modeling at the tool-chip interface has a significant influence on the final results. Therefore, it can be concluded that the friction coefficient has a strong effect in the cutting process and is crucial to obtain valuable predictions when machining with the FEM model.

[1]  J. Paulo Davim,et al.  Precision radial turning of AISI D2 steel , 2008 .

[2]  M. Nalbant,et al.  The effects of cutting tool geometry and processing parameters on the surface roughness of AISI 1030 steel , 2007 .

[3]  Tuğrul Özel,et al.  Journal of Materials Processing Technology Computational Modelling of 3d Turning: Influence of Edge Micro-geometry on Forces, Stresses, Friction and Tool Wear in Pcbn Tooling , 2022 .

[4]  D. Umbrello,et al.  Experimental and numerical modelling of the residual stresses induced in orthogonal cutting of AISI 316L steel , 2006 .

[5]  Faraz Akbar,et al.  Predictive modelling of average heat partition in high speed machining of AISI/SAE 4140 steel , 2009 .

[6]  Edoardo Capello,et al.  Residual stresses in turning: Part I: Influence of process parameters , 2005 .

[7]  M. H. El-Axir,et al.  A method of modeling residual stress distribution in turning for different materials , 2002 .

[8]  I. S. Jawahir,et al.  On the Effects of Residual Stresses Induced by Coated and Uncoated Cutting Tools with Finite Edge Radii in Turning Operations , 2006 .

[9]  A. Dias,et al.  Residual stress analysis in orthogonal machining of standard and resulfurized AISI 316L steels , 1999 .

[10]  G. Boothroyd,et al.  Fundamentals of machining and machine tools , 2006 .

[11]  P. Dahlman,et al.  The influence of rake angle, cutting feed and cutting depth on residual stresses in hard turning , 2004 .

[12]  M. E. Merchant Mechanics of the Metal Cutting Process. II. Plasticity Conditions in Orthogonal Cutting , 1945 .

[13]  S. Engin Kilic,et al.  A comparison of orthogonal cutting data from experiments with three different finite element models , 2004 .

[14]  Pedro J. Arrazola,et al.  A new approach for the friction identification during machining through the use of finite element modeling , 2008 .

[15]  D. Umbrello,et al.  The influence of Johnson–Cook material constants on finite element simulation of machining of AISI 316L steel , 2007 .

[16]  Ulvi Seker,et al.  Investigation of chip-back temperature during machining depending on cutting parameters , 2007 .