Stress Analysis of Partially Yielded Soldered Joint for Surface Mount Connectors

A closed-form solution is derived for deformation of Partially yielded L-shaped joints commonly seen in surface mount connectors. The solder layer is modeled by one-dimensional elastic/ plastic foundation. The solution agrees well with a published result of an elastic problem as a special case and with a finite element analysis in an elastic/plastic case. This analysis provides a few useful conclusions in the design of soldering leads. They are 1) the soldering lead (but not the vertical portion) should be thick to distribute the load in a larger area, and 2) peel stress may be reduced by appropriately including a moment to counteract the effect Of vertical force.

[1]  E. Baker,et al.  Stress relaxation in Tin-Lead solders , 1979 .

[2]  D. Updike,et al.  Stress Analysis of Bonded Plates and Joints , 1980 .

[3]  F. Erdogan,et al.  Stress Distribution in Bonded Joints * , 1971 .

[4]  G. S. Murty,et al.  Experimental constitutive relations for the high temperature deformation of a PbSn eutectic alloy , 1981 .

[5]  S. Yamada,et al.  A Mechanism for Board Warpage by Thermal Expansion of Surface Mounted Connector , 1986 .

[6]  E. Baker,et al.  The Influence of Temperature on Stress Relaxation in a Chill-Cast, Tin-Lead Solder , 1973 .

[7]  M. Williams.  The fracture threshold for an adhesive interlayer , 1970 .

[8]  E. Sternberg,et al.  On the stress analysis of overlapping bonded elastic sheets , 1968 .

[9]  James H. Williams,et al.  Stresses in Adhesive between Dissimilar Adherends , 1975 .

[10]  F. Erdogan,et al.  Viscoelastic Analysis of Adhesively Bonded Joints , 1981 .

[11]  T. Langdon,et al.  Ductility of the superplastic Pb-Sn eutectic at room temperature , 1983 .

[12]  Du Chen,et al.  An Analysis of Adhesive-Bonded Single-Lap Joints , 1983 .

[13]  Thein Wah,et al.  Stress Distribution in a Bonded Anisotropic Lap Joint , 1973 .

[14]  M. N. Aydınoğlu,et al.  Stresses in Adhesively Bonded Joints: A Closed-Form Solution , 1980 .

[15]  C W Woo,et al.  On the determination and application of cod to epoxy-bonded aluminium joints , 1979 .

[16]  Jack R. Vinson,et al.  The Efficient Design of Adhesive Bonded Joints , 1975 .