Data reduction scheme for measuring G IIc of wood in end-notched flexure (ENF) tests

Abstract Numerical and experimental studies of end-notched flexure (ENF) fracture tests were performed to obtain mode II R curves for maritime pine (Pinus pinaster Ait.) wood in the radial-longitudinal (RL) crack propagation system. Three- (3D) and two-dimensional (2D) finite element analyses were conducted to determine the mode II release rate of the critical strain energy (G IIc). The 3D analysis revealed that a small spurious mode III component did not affect G IIc measurements and that the 2D model was very accurate. A new scheme for data reduction based on the equivalent crack concept is proposed to overcome the difficulties related to accurate crack length measurement during propagation. This method does not require previous experimental tests to obtain the elastic modulus, which varies markedly for different wood specimens. Experimental ENF tests were performed to verify the numerical results. The results demonstrate the accuracy of the data reduction method proposed.

[1]  Hiroshi Yoshihara,et al.  Mode II R-curve of wood measured by 4-ENF test , 2004 .

[2]  José Morais,et al.  Equivalent crack based mode II fracture characterization of wood , 2006 .

[3]  M. Kanninen,et al.  A finite element calculation of stress intensity factors by a modified crack closure integral , 1977 .

[4]  A. T. Marques,et al.  Modeling Compression Failure after Low Velocity Impact on Laminated Composites Using Interface Elements , 1997 .

[5]  Ian Smith,et al.  Fracture behaviour of softwood , 2003 .

[6]  P.M.S.T. de Castro,et al.  Interface element including point‐to‐surface constraints for three‐dimensional problems with damage propagation , 2000 .

[7]  R. O. Foschi,et al.  Mode II stress-intensity factors for cracked wood beams , 1977 .

[8]  Hiroshi Yoshihara,et al.  Measurement of mode II fracture toughness of wood by the end-notched flexure test , 2000, Journal of Wood Science.

[9]  L. Daudeville,et al.  Prediction of the load carrying capacity of bolted timber joints , 1999, Wood Science and Technology.

[10]  Janez Kopac,et al.  Wood: an important material in manufacturing technology , 2003 .

[11]  J. G. Williams,et al.  Corrections for mode II fracture toughness specimens of composites materials , 1992 .

[12]  Anthony J. Kinloch,et al.  The determination of the mode II adhesive fracture resistance, GIIC, of structural adhesive joints: an effective crack length approach , 2005 .

[13]  M. Kanninen,et al.  Advanced Fracture Mechanics , 1986 .

[14]  José Morais,et al.  Mode II wood fracture characterization using the ELS test , 2007 .

[15]  A. G. Zink,et al.  Ultrastructural analysis of softwood fracture surfaces , 1994, Wood Science and Technology.