论文信息 - Design and implementation of fast output sampling feedback control for shape memory alloy actuated structures

Design and implementation of fast output sampling feedback control for shape memory alloy actuated structures

This paper presents the design and experimental evaluation of fast output sampling feedback controller to minimize structural vibration of a cantilever beam using Shape Memory Alloy (SMA) wires as control actuators and piezoceramics as sensor and disturbance actuator. Linear dynamic models of the smart cantilever beam are obtained using online recursive least square parameter estimation. A digital control system that consists of modeling software and dSPACE DS1104 controller board is used for identification and control. The effectiveness of the controller is shown through simulation and experimentation by exciting the structure at resonance.

Bijnan Bandyopadhyay | Mangalanathan Umapathy | D. Ezhilarasi | K. Dhanalakshmi

[1] Seung-Bok Choi,et al. VIBRATION CONTROL OF A FLEXIBLE BEAM USING SHAPE MEMORY ALLOY ACTUATORS , 1996 .

[2] Lin Ye,et al. Active control of a flexible smart beam using a system identification technique based on ARMAX , 2003 .

[3] Stefan Seelecke,et al. Shape memory alloy actuators in smart structures: Modeling and simulation , 2004 .

[4] Katsuhisa Furuta,et al. Simultaneous stabilization based on output measurement , 1995, Kybernetika.

[5] Gangbing Song,et al. Position estimation and control of SMA actuators based on electrical resistance measurement , 2007 .

[6] Bijnan Bandyopadhyay,et al. Design and experimental evaluation of piecewise output feedback control for structural vibration suppression , 2006 .

[7] Amr M. Baz,et al. Active vibration control of flexible beams using shape memory actuators , 1990 .

[8] Seung-Bok Choi,et al. Vibration and Position Tracking Control of a Flexible Beam Using SMA Wire Actuators , 2009 .