High-purity oxygen production by a dead-end Ba0.5Sr0.5Co0.8Fe0.2O3-delta tube membrane

Abstract High-purity oxygen was produced by dead-end Ba 0.5 Sr 0.5 Co 0.8 Fe 0.2 O 3− δ (BSCF) tube membranes which were sealed by a reaction-diffusion sintering process. First, phase stability of BSCF membrane in a pure oxygen atmosphere – as it is present on the permeate side of the membrane – was studied at 750 and 950 °C, respectively. After the identification of stable operation conditions of BSCF membranes, we studied the oxygen permeation at 950 °C using dead-end BSCF tubes (1 cm outer diameter, 1 mm wall thickness) in (i) a pressure-driven process, (ii) a vacuum process, and (iii) combining both techniques. In all cases, a high oxygen purity of almost 100 vol.% can be obtained at operation temperatures ≥ 850 °C. The oxygen permeation flux, the oxygen recovery, and the oxygen ionic conductivity were investigated. It was found that – for the same oxygen partial pressure difference – the oxygen permeation flux in the vacuum process is significantly higher than that in the pressure-driven process at all investigated temperatures. Moreover, in all cases, oxygen permeation and oxygen ionic conductivity can be described by the Wagner theory for bulk diffusion of oxygen ions as rate-limiting step with the logarithmic ratio of the oxygen partial pressures on feed and permeate sides as driving force.

[1]  J. Caro,et al.  Investigation of phase structure, sintering, and permeability of perovskite-type Ba0.5Sr0.5Co0.8Fe0.2O3−δ membranes , 2005 .

[2]  Hui Lu,et al.  Partial oxidation of methane in Ba0.5Sr0.5Co0.8Fe0.2O3−δ membrane reactor at high pressures , 2005 .

[3]  Wei Zhou,et al.  A dense oxygen separation membrane with a layered morphologic structure , 2007 .

[4]  Zongping Shao,et al.  A high-performance cathode for the next generation of solid-oxide fuel cells , 2004, Nature.

[5]  Xiaoyao Tan,et al.  Pilot-scale production of oxygen from air using perovskite hollow fibre membranes , 2010 .

[6]  W. Haije,et al.  Properties and performance of BaxSr1−xCo0.8Fe0.2O3−δ materials for oxygen transport membranes , 2006 .

[7]  K. Efimov,et al.  Transmission Electron Microscopy Study of Ba0.5Sr0.5Co0.8Fe0.2O3−δ Perovskite Decomposition at Intermediate Temperatures , 2010 .

[8]  H. Bouwmeester,et al.  Oxygen permeation of La0.3Sr0.7CoO3−δ , 1997 .

[9]  Xuefeng Zhu,et al.  Operation of perovskite membrane under vacuum and elevated pressures for high-purity oxygen production , 2009 .

[10]  Jaka Sunarso,et al.  Mixed ionic-electronic conducting (MIEC) ceramic-based membranes for oxygen separation , 2008 .

[11]  D. T. Liang,et al.  Experimental and modeling studies on Ba0.5Sr0.5Co0.8Fe0.2O3−δ (BSCF) tubular membranes for air separation , 2004 .

[12]  C. Wagner,et al.  Equations for transport in solid oxides and sulfides of transition metals , 1975 .

[13]  A. Feldhoff,et al.  Correlation of the Formation and the Decomposition Process of the BSCF Perovskite at Intermediate Temperatures , 2008 .

[14]  K. Wiik,et al.  Structural instability of cubic perovskite BaxSr1 − xCo1 − yFeyO3 − δ , 2008 .

[15]  E. Ivers-Tiffée,et al.  Decomposition pathway of cubic Ba0.5Sr0.5Co0.8Fe0.2O3 − δ between 700 °C and 1000 °C analyzed by electron microscopic techniques , 2012 .

[16]  Armin Feldhoff,et al.  Phase Stability and Permeation Behavior of a Dead-End Ba(0.5)Sr(0.5)Co(0.8)Fe(0.2)O(3-delta) Tube Membrane in High-Purity Oxygen Production , 2011 .

[17]  Ito Wataru,et al.  Oxygen separation from compressed air using a mixed conducting perovskite-type oxide membrane , 2007 .

[18]  Shaomin Liu,et al.  Production of pure oxygen from BSCF hollow fiber membranes using steam sweep , 2011 .

[19]  A. Veen,et al.  Oxidative activation of ethane on catalytic modified dense ionic oxygen conducting membranes , 2005 .

[20]  C. Mirodatos,et al.  Studies on the performance stability of mixed conducting BSCFO membranes in medium temperature oxygen permeation. , 2003, Chemical communications.

[21]  J. Caro,et al.  High-Purity Oxygen Production from Air Using Perovskite Hollow Fiber Membranes , 2010 .

[22]  X. Tan,et al.  Oxygen production using dense ceramic hollow fiber membrane modules with different operating modes , 2007 .

[23]  Zongping Shao,et al.  Investigation of the permeation behavior and stability of a Ba0.5Sr0.5Co0.8Fe0.2O3−δ oxygen membrane , 2000 .

[24]  A. Kovalevsky,et al.  Processing and oxygen permeation studies of asymmetric multilayer Ba 0.5Sr 0.5Co 0.8Fe 0.2O 3- d mem , 2011 .

[25]  Shumin Fang,et al.  Phase transformation and oxygen equilibration kinetics of pure and Zr-doped Ba0.5Sr0.5Co0.8Fe0.2O3−δ perovskite oxide probed by electrical conductivity relaxation , 2010 .

[26]  J. Caro,et al.  Perovskite hollow-fiber membranes for the production of oxygen-enriched air. , 2005, Angewandte Chemie.

[27]  J. Caro,et al.  Production of high-purity oxygen by perovskite hollow fiber membranes swept with steam , 2006 .

[28]  R. Kriegel,et al.  Oxygen stoichiometry and expansion behavior of Ba0.5Sr0.5Co0.8Fe0.2O3 − δ , 2010 .