A solution processed Sb2S3-based photocathode with enhanced photocatalytic performance via constructing an ultrathin TiO2 overlayer and noble metal modification

An ultrathin TiO2 overlayer was deposited on nano-structured Sb2S3 absorption layers by a simple electrodeposition method, effectively increasing photoelectrochemical conversion and the onset potential of a photocathode for solar water splitting.

[1]  Z. Ye,et al.  A Stable and Efficient Photocathode Using an Sb2S3 Absorber in a Near-Neutral Electrolyte for Water Splitting , 2020, ACS Applied Energy Materials.

[2]  P. Ding,et al.  Photocathode engineering for efficient photoelectrochemical CO2 reduction , 2020 .

[3]  Somnath C. Roy,et al.  CuO/Cu2O nanoflake/nanowire heterostructure photocathode with enhanced surface area for photoelectrochemical solar energy conversion , 2020 .

[4]  L. You,et al.  Enhanced Photoelectrochemical Performance by Interface Engineering in Ternary g‐C3N4/TiO2/PbTiO3 Films , 2020, Advanced Materials Interfaces.

[5]  A. Paul,et al.  Atomic layer deposition of amorphous antimony sulfide (a-Sb2S3) as semiconductor sensitizer in extremely thin absorber solar cell , 2020 .

[6]  Zhifeng Liu,et al.  Decorating Cu2O photocathode with noble-metal-free Al and NiS cocatalysts for efficient photoelectrochemical water splitting by light harvesting management and charge separation design , 2020 .

[7]  C. Bittencourt,et al.  Engineering crystal phase of polytypic CuInS2 nanosheets for enhanced photocatalytic and photoelectrochemical performance , 2020, Nano Research.

[8]  Zhifeng Liu,et al.  Co-Modification with Cost-Effective Nickel Oxides and Nickel Sulfides on CuInS2 Nanosheets Photocathode for Enhanced Photoelectrochemical Performance , 2020 .

[9]  Ruchuan Liu,et al.  A highly [001]-textured Sb2Se3 photocathode for efficient photoelectrochemical water reduction. , 2019, Nanoscale.

[10]  Xuanhua Li,et al.  Solution processed Sb2S3 planar thin film solar cell of conversion efficiency 6.9% at open circuit voltage 0.7 V achieved via surface passivation by SbCl3 interface layer. , 2019, ACS applied materials & interfaces.

[11]  Li-ping Zhu,et al.  Cu2O photocathodes for unassisted solar water-splitting devices enabled by noble-metal cocatalysts simultaneously as hydrogen evolution catalysts and protection layers , 2019, Nanotechnology.

[12]  Zhifeng Liu,et al.  CuInS2/Sb2S3 heterostructure modified with noble metal co-catalyst for efficient photoelectrochemical water splitting , 2019, Journal of Alloys and Compounds.

[13]  Jooho Moon,et al.  Cu-Doped NiOx as an Effective Hole-Selective Layer for a High-Performance Sb2Se3 Photocathode for Photoelectrochemical Water Splitting , 2019, ACS Energy Letters.

[14]  Yun Sun,et al.  Substrate structured Sb2S3 thin film solar cells fabricated by rapid thermal evaporation method , 2019, Solar Energy.

[15]  F. Toma,et al.  Si photocathode with Ag-supported dendritic Cu catalyst for CO2reduction , 2019, Energy & Environmental Science.

[16]  Ming Jia,et al.  Fabrication of Sb2S3 thin films by sputtering and post-annealing for solar cells , 2019, Ceramics International.

[17]  Seungmin Lee,et al.  Time-Resolved Observations of Photo-Generated Charge-Carrier Dynamics in Sb2Se3 Photocathodes for Photoelectrochemical Water Splitting. , 2018, ACS nano.

[18]  Shichong Xu,et al.  One pot synthesis of Sb2S3 nanocrystalline films through a PVP-assisted hydrothermal process , 2018, Applied Surface Science.

[19]  Joondong Kim,et al.  Thickness-dependent photoelectrochemical properties of a semitransparent Co3O4 photocathode , 2018, Beilstein journal of nanotechnology.

[20]  Junsheng Yu,et al.  Enhanced Photovoltaic Properties in Sb2S3 Planar Heterojunction Solar Cell with a Fast Selenylation Approach , 2018, Nanoscale Research Letters.

[21]  Xin Jiang,et al.  Scalable Low-Band-Gap Sb2Se3 Thin-Film Photocathodes for Efficient Visible-Near-Infrared Solar Hydrogen Evolution. , 2017, ACS nano.

[22]  T. Moehl,et al.  Photocorrosion-resistant Sb2Se3 photocathodes with earth abundant MoSx hydrogen evolution catalyst , 2017 .

[23]  Jiang Tang,et al.  Postsurface Selenization for High Performance Sb2S3 Planar Thin Film Solar Cells , 2017 .

[24]  Zhifeng Liu,et al.  Efficient all p-type heterojunction photocathodes for photoelectrochemical water splitting. , 2017, Dalton transactions.

[25]  Jiang Tang,et al.  Efficient and stable TiO2/Sb2S3 planar solar cells from absorber crystallization and Se-atmosphere annealing , 2017 .

[26]  Zhifeng Liu,et al.  Efficient photoelectrochemical water splitting over Co3O4 and Co3O4/Ag composite structure , 2017 .

[27]  Y. Mai,et al.  Efficiency enhancement of Sb2Se3 thin-film solar cells by the co-evaporation of Se and Sb2Se3 , 2016 .

[28]  Jurriaan Huskens,et al.  Effects of Pillar Height and Junction Depth on the Performance of Radially Doped Silicon Pillar Arrays for Solar Energy Applications , 2016 .

[29]  Zheng Jiang,et al.  Recent Advances in Visible-Light-Driven Photoelectrochemical Water Splitting: Catalyst Nanostructures and Reaction Systems , 2015, Nano-micro letters.

[30]  B. Bessaïs,et al.  Effect of substrate temperature on the structural, morphological, and optical properties of Sb2S3 thin films , 2015 .

[31]  L. Etgar,et al.  High Open Circuit Voltage in Sb2S3/Metal Oxide-Based Solar Cells , 2015 .

[32]  M. Shen,et al.  Stable and efficient multi-crystalline n+p silicon photocathode for H2 production with pyramid-like surface nanostructure and thin Al2O3 protective layer , 2015 .

[33]  S. Sung,et al.  Highly reproducible planar Sb₂S₃-sensitized solar cells based on atomic layer deposition. , 2014, Nanoscale.

[34]  Dong Uk Lee,et al.  Highly Improved Sb2S3 Sensitized‐Inorganic–Organic Heterojunction Solar Cells and Quantification of Traps by Deep‐Level Transient Spectroscopy , 2014 .

[35]  Danielle M. Schultz,et al.  Solar Synthesis: Prospects in Visible Light Photocatalysis , 2014, Science.

[36]  G. Dennler,et al.  On Charge Carrier Recombination in Sb2S3 and Its Implication for the Performance of Solar Cells , 2013 .

[37]  Kosi C Aroh,et al.  Copper oxide photocathodes prepared by a solution based process , 2012 .

[38]  I. Bello,et al.  Hybrid photovoltaic cells based on ZnO/Sb2S3/P3HT heterojunctions , 2012 .

[39]  Wanxi Zhang,et al.  Synthesis and characterization of single-crystal Sb2S3 nanotubes via an EDTA-assisted hydrothermal route , 2010 .

[40]  Gary Hodes,et al.  Sb2S3-Sensitized Nanoporous TiO2 Solar Cells , 2009 .

[41]  C. H. Bhosale,et al.  Preparation and characterization of spray deposited photoactive Sb2S3 and Sb2Se3 thin films using aqueous and non-aqueous media , 2002 .

[42]  G. Horowitz.  Photocurrent onset potential and flatband potential of a p‐type GaP semiconducting photoelectrode , 1982 .