Performance Analysis of PEMFC with Single-Channel and Multi-Channels on the Impact of the Geometrical Model

A low-performance fuel cell significantly hinders the application and commercialization of fuel cell technology. Computational fluid dynamics modeling could predict and evaluate the performance of a proton exchange membrane fuel cell (PEMFC) with less time consumption and cost-effectiveness. PEMFC performance is influenced by the distribution of reactants, water, heat, and current density. An uneven distribution of reactants leads to the localization of current density that produces heat and water, which are the by-products of the reaction to be concentrated at the location. The simplification of model geometry can affect performance prediction. Numerical investigations are commonly validated with experimental results to validate the method’s accuracy. Poor prediction of PEMFC results has not been discussed. Thus, this study aims to predict the effect of geometry modeling on fuel cell performance. Two contrasting 3D model dimensions, particularly single-channel and small-scale seven-channel models were employed. Both 3D models are correlated with a multi-channel model to assess the effect of modeling dimension on the PEMFC performance. Similar stoichiometry and channel dimensions were imposed on each model, where theoretically, the PEMFC performance should be identical. The simulation findings showed that the single-channel model produced a higher current density per cm2. From the contours of water and current density, the single-channel model does not show flow distribution. Thus, this leads to a higher current density generation than the small-scale model. The prediction of PEMFC performance is not thorough for the single-channel model. Therefore, the prediction of PEMFC performance is adaptable in a small-scale or comprehensive flow field.

[1]  Hongtao Xu,et al.  Numerical investigation on the performance of PEMFC with rib-like flow channels , 2022, International Journal of Hydrogen Energy.

[2]  Qiong Tan,et al.  Numerical simulation analysis of the performance on the PEMFC with a new flow field designed based on constructal-theory , 2022, International Journal of Hydrogen Energy.

[3]  Hang Guo,et al.  Effect of liquid water accumulation in electrolytic cell mode on start-up performance of fuel cell mode of unitized regenerative fuel cells , 2022, Energy Conversion and Management.

[4]  F. Jiang,et al.  Analysis of the impact of flow field arrangement on the performance of PEMFC with zigzag-shaped channels , 2021, International Journal of Heat and Mass Transfer.

[5]  Fei Dong,et al.  Influence of Microelliptical Groove Gas Diffusion Layer (GDL) on Transport Behavior of Proton Exchange Membrane Fuel Cell (PEMFC) , 2021 .

[6]  Haozhong Huang,et al.  Geometry optimization and performance analysis of a new tapered slope cathode flow field for PEMFC , 2021, International Journal of Hydrogen Energy.

[7]  S. Kamarudin,et al.  The progress of fuel cell for malaysian residential consumption: Energy status and prospects to introduction as a renewable power generation system , 2021, Renewable and Sustainable Energy Reviews.

[8]  Liu Shun,et al.  A numerical study on the performance of PEMFC with wedge-shaped fins in the cathode channel , 2021, International Journal of Hydrogen Energy.

[9]  K. Blok,et al.  Fuel cell electric vehicles and hydrogen balancing 100 percent renewable and integrated national transportation and energy systems , 2021, Energy Conversion and Management: X.

[10]  Q. Du,et al.  Numerical simulation of liquid water emerging and transport in the flow channel of PEMFC using the volume of fluid method , 2020 .

[11]  Zhonghua Shi,et al.  Optimization of serpentine flow field in proton-exchange membrane fuel cell under the effects of external factors , 2020 .

[12]  Wenbin Li,et al.  Performance investigation on a novel 3D wave flow channel design for PEMFC , 2020 .

[13]  M. Rahimi-Esbo,et al.  Novel design and numerical evaluating of a cooling flow field in PEMFC with metallic bipolar plates , 2020 .

[14]  W. Daud,et al.  Numerical investigation of the effect of three-dimensional modified parallel flow field designs on proton exchange membrane fuel cell performance , 2020 .

[15]  T. Rajagopal,et al.  Numerical and experimental investigation on 25 cm2 and 100 cm2 PEMFC with novel sinuous flow field for effective water removal and enhanced performance , 2020 .

[16]  Tong Zhang,et al.  Influencing sensitivities of critical operating parameters on PEMFC output performance and gas distribution quality under different electrical load conditions , 2019 .

[17]  Shihua Liu,et al.  Numerical simulation and experimental study on the effect of symmetric and asymmetric bionic flow channels on PEMFC performance under gravity , 2019, International Journal of Hydrogen Energy.

[18]  X. Zhuang,et al.  Experimental and numerical investigation on effects of cathode flow field configurations in an air-breathing high-temperature PEMFC , 2019, International Journal of Hydrogen Energy.

[19]  Tabbi Wilberforce,et al.  Numerical modelling and CFD simulation of a polymer electrolyte membrane (PEM) fuel cell flow channel using an open pore cellular foam material. , 2019, The Science of the total environment.

[20]  K. Jiao,et al.  Numerical analysis of operating conditions effects on PEMFC with anode recirculation , 2019, Energy.

[21]  W. Daud,et al.  Three-dimensional study of stack on the performance of the proton exchange membrane fuel cell , 2019, Energy.

[22]  Yan Yin,et al.  Numerical investigation on the characteristics of mass transport and performance of PEMFC with baffle plates installed in the flow channel , 2018 .

[23]  Wan Ramli Wan Daud,et al.  Numerical analysis of modified parallel flow field designs for fuel cells , 2017 .

[24]  J. Macedo-Valencia,et al.  3D CFD modeling of a PEM fuel cell stack , 2016 .

[25]  I. Eroglu,et al.  Modeling and sensitivity analysis of high temperature PEM fuel cells by using Comsol Multiphysics , 2016 .

[26]  Wan Ramli Wan Daud,et al.  Effects of flow field design on water management and reactant distribution in PEMFC: a review , 2016, Ionics.

[27]  S. Perng,et al.  A three-dimensional numerical investigation of trapezoid baffles effect on non-isothermal reactant transport and cell net power in a PEMFC , 2015 .

[28]  Xiao-dong Wang,et al.  Performance study on a stepped flow field design for bipolar plate in PEMFC , 2021 .

[29]  Shuhuai Lan,et al.  Performance evaluation of commercial-size proton exchange membrane fuel cell stacks considering air flow distribution in the manifold , 2020 .

[30]  Ahmet Kusoglu,et al.  A Critical Review of Modeling Transport Phenomena in Polymer-Electrolyte Fuel Cells , 2014 .