Natural laminar flow experiments on modern airplane surfaces

Flight and wind-tunnel natural laminar flow experiments have been conducted on various lifting and nonlifting surfaces of several airplanes at unit Reynolds numbers between 0.63 x 10 to the 6th power/ft and 3.08 x 10 to the 6th power/ft, at Mach numbers from 0.1 to 0.7, and at lifting surface leading-edge sweep angles from 0 deg to 63 deg. The airplanes tested were selected to provide relatively stiff skin conditions, free from significant roughness and waviness, on smooth modern production-type airframes. The observed transition locations typically occurred downstream of the measured or calculated pressure peak locations for the test conditions involved. No discernible effects on transition due to surface waviness were observed on any of the surfaces tested. None of the measured heights of surface waviness exceeded the empirically predicted allowable surface waviness. Experimental results consistent with spanwise contamination criteria were observed. Large changes in flight-measured performance and stability and control resulted from loss of laminar flow by forced transition. Rain effects on the laminar boundary layer caused stick-fixed nose-down pitch-trim changes in two of the airplanes tested. No effect on transition was observed for flight through low-altitude liquid-phase clouds. These observations indicate the importance of fixed-transition tests as a standard flight testing procedure for modern smooth airframes.

[1]  L.M.M. Boermans,et al.  On the design of some airfoils for sailplane application , 1981 .

[2]  W. S. Coleman.  ROUGHNESS DUE TO INSECTS , 1961 .

[3]  Handel Davies.  Some Aspects of Flight Research , 1951 .

[4]  H. L. Morgan,et al.  Mathematical model for two-dimensional multi-component airfoils in viscous flow. , 1972 .

[5]  B. J. Holmes.  Low-speed airspeed calibration data for a single-engine research-support aircraft , 1980 .

[6]  D. Kohlman,et al.  Icing tunnel tests of a glycol-exuding porous leading edge ice protection system on a general aviation airfoil , 1981 .

[7]  G. R. Hall,et al.  Interaction of the wake from bluff bodies with an initially laminar boundary layer. , 1966 .

[8]  John A. Zalovcik.  Flight Investigation of Boundary-Layer and Profile-Drag Characteristics of Smooth Wing Sections of a P-47D Airplane , 1945 .

[9]  L. L. Steers,et al.  F-111 TACT natural laminar flow glove flight results , 1981 .

[10]  Robert C Platt.  A flight investigation of the boundary-layer characteristics and profile drag of the NACA 35-215 laminar-flow airfoil at high Reynolds numbers , 1941 .

[11]  Itiro Tani.  On the design of airfoils in which the transition of the boundary layer is delayed , 1952 .

[12]  L. P. Yip,et al.  Wind-tunnel investigation of a full-scale canard-configured general aviation aircraft , 1982 .

[13]  Albert L. Braslow,et al.  Simplified method for determination of critical height of distributed roughness particles for boundary-layer transition at Mach numbers from 0 to 5 , 1958 .

[14]  L. K. Loftin.  Subsonic aircraft: Evolution and the matching of size to performance , 1980 .

[15]  C. J. Obara,et al.  Observations and implications of natural laminar flow on practical airplane surfaces , 1983 .

[16]  D. M. Bushnell,et al.  Survey and bibliography on attainment of laminar flow control in air using pressure gradient and suction, volume 1 , 1979 .

[17]  Antony Jameson,et al.  A multi-grid method for the computation of viscid/inviscid interactions on airfoils , 1983 .

[18]  John A. Zalovcik,et al.  Flight Investigation at High Speeds of Profile Drag of Wing of a P-47D Airplane Having Production Surfaces Covered with Camouflage Paint , 1946 .

[19]  Joseph Bicknell,et al.  Determination of the profile drag of an airplane wing in flight at high Reynolds numbers , 1939 .

[20]  B. H. Carmichael.  Summary of past experience in natural laminar flow and experimental program for resilient leading edge , 1979 .

[21]  Joseph Bicknell,et al.  Comparison of Profile-Drag and Boundary-Layer Measurements Obtained in Flight and in the Full-Scale Wind Tunnel , 1939 .

[22]  A. C. Hardy,et al.  Studies in the Distribution of Insects by Aerial Currents , 1938 .

[23]  J Stuper.  Investigation of boundary layers on an airplane wing in free flight , 1934 .

[24]  R. D. Gilkey,et al.  Design and wind tunnel tests of winglets on a DC-10 wing , 1979 .

[25]  G. R. Hall.  On the Mechanics of Transition Produced by Particles Passing Through an Initially Laminar Boundary Layer and the Estimated Effect on the LFC Performance of the X-21 Aircraft , 1964 .

[26]  C. J. Wenzinger.  Wind-tunnel investigation of several factors affecting the performance of a high-speed pursuit airplane with air-cooled radial engine , 1941 .

[27]  John A. Zalovcik.  Profile-Drag Coefficients of Conventional and Low-Drag Airfoils as Obtained in Flight , 1944 .

[28]  Dan M. Somers,et al.  A computer program for the design and analysis of low-speed airfoils, supplement , 1980 .

[29]  Richard D. Banner,et al.  Boundary-Layer-Transition Measurements in Full-Scale Flight , 1958 .

[30]  R. Davis,et al.  Cloud-encounter and particle-concentration variabilities from GASP data , 1981 .

[31]  J. A. Zalovcik,et al.  Flight investigation of boundary-layer transition and profile drag of an experimental low-drag wing installed on a figher-type airplane , 1945 .