Design methodology for membrane-based plate-and-frame fuel cell humidifiers

Currently, polymer electrolyte membrane fuel cells require some method of humidification to operate effectively. External gas-to-gas membrane-based humidifiers can provide an efficient method to recycle exhaust heat and product water from the fuel cell stack. This work describes a design methodology involving a series of design equations for plate-and-frame membrane humidifiers. Humidifiers of different flow channel geometries were created with a rapid prototyping technique. These humidifier units were tested at different operating conditions in an attempt to validate the design equations. The ratio between the residence time of gas in the humidifier over the diffusion time of water from the surface of the membrane into the channel can be used as a design parameter. This ratio was shown to offer a good starting point for humidifier design, and a target range between 2.0 and 4.0 was identified (with a nominal desired value of 3.0). A humidifier design procedure and suggestions are presented based on this parameter and the packaging requirements of the humidifier in a fuel cell system. This algorithm was validated by creating a further prototype humidifier.

[1]  Zhigang Qi,et al.  PEM fuel cell stacks operated under dry-reactant conditions , 2002 .

[2]  Walter Mérida,et al.  Water flux in membrane fuel cell humidifiers : Flow rate and channel location effects , 2008 .

[3]  T. Nguyen,et al.  Effect of direct liquid water injection and interdigitated flow field on the performance of proton exchange membrane fuel cells , 1998 .

[4]  Felix N. Büchi,et al.  Modular Stack‐Internal Air Humidification Concept‐Verification in a 1 kW Stack , 2004 .

[5]  I. Hsing,et al.  Internally humidified polymer electrolyte fuel cells using water absorbing sponge , 2005 .

[6]  R. Shah.  Laminar Flow Forced convection in ducts , 1978 .

[7]  Yongzhu Fu,et al.  Development of novel self-humidifying composite membranes for fuel cells , 2003 .

[8]  Zhigang Qi,et al.  Enhancement of PEM fuel cell performance by steaming or boiling the electrode , 2002 .

[9]  Hiroyuki Uchida,et al.  Self-Humidifying Electrolyte Membranes for Fuel Cells Preparation of Highly Dispersed TiO 2 Particles in Nafion 112 , 2003 .

[10]  Natarajan Rajalakshmi,et al.  Identification and characterization of parameters for external humidification used in polymer electrolyte membrane fuel cells , 2002 .

[11]  M. Watanabe,et al.  Management of the Water Content in Polymer Electrolyte Membranes with Porous Fiber Wicks , 1993 .

[12]  Hiroyuki Uchida,et al.  Self‐Humidifying Polymer Electrolyte Membranes for Fuel Cells , 1996 .

[13]  Ralph E. White,et al.  A water and heat management model for proton-exchange-membrane fuel cells , 1993 .

[14]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .