Effect of humidity changes on dimensional stability of 3D printed parts by selective laser sintering

[1]  S. Das,et al.  Processing and properties of electrically conductive nanocomposites based on polyamide-12 filled with exfoliated graphite nanoplatelets prepared by selective laser sintering , 2013 .

[2]  I. Gibson,et al.  Selective laser sintered Castform polystyrene with controlled porosity and its infiltration by red wax , 2002 .

[3]  H. Thomas Hahn,et al.  Characterization of the laminated object manufacturing (LOM) process , 2000 .

[4]  O. Lame,et al.  Microstructural origin of physical and mechanical properties of polyamide 12 processed by laser sintering , 2012 .

[5]  Vojislav Petrovic,et al.  Additive layered manufacturing: sectors of industrial application shown through case studies , 2011 .

[6]  Wan-Sik Woo,et al.  Laser and arc manufacturing processes: A review , 2016 .

[7]  Jintamai Suwanprateeb.  Comparative study of 3DP material systems for moisture resistance applications , 2007 .

[8]  K. Ehmann,et al.  RETRACTED ARTICLE: Feasibility of using Copper(II)Oxide for additive manufacturing , 2014 .

[9]  Ming-Chuan Leu,et al.  Additive manufacturing: technology, applications and research needs , 2013, Frontiers of Mechanical Engineering.

[10]  Christopher J. Sutcliffe,et al.  Selective laser melting of high aspect ratio 3D nickel–titanium structures two way trained for MEMS applications , 2008 .

[11]  P. Vallittu,et al.  The influence of short-term water storage on the flexural properties of unidirectional glass fiber-reinforced composites. , 2002, Biomaterials.

[12]  T. Benameur,et al.  Hardness variation of a thermoset in contact with a liquid , 1997 .

[13]  Chee Meng Benjamin Ho,et al.  A review on 3D printed bioimplants , 2015 .

[14]  Hae-yong Cho,et al.  3-dimensional circuit device fabrication process using stereolithography and direct writing , 2015 .

[15]  J. Jiang,et al.  Environmental effects on the dimensions of SL5195 resin , 2003 .

[16]  D. Bourell,et al.  Performance Limitations in Polymer Laser Sintering , 2014 .

[17]  B. A. Dunell,et al.  Dynamic mechanical properties of nylon 66 and the plasticizing effect of water vapor on nylon , 1958 .

[18]  R. Meredith,et al.  Dynamic bending properties of fibers: Effect of temperature on nylon 66, terylene, orlon, and viscose rayon , 1962 .

[19]  K. Ehmann,et al.  Retraction Note: Feasibility of using copper(II)oxide for additive manufacturing , 2014 .

[20]  Sanjay Kumar,et al.  An experimental design approach to selective laser sintering of low carbon steel , 2003 .