Electrical Properties of Polyethylene/Polypropylene Compounds for High-Voltage Insulation

In high-voltage insulation systems, the most commonly used material is polymeric material because of its high dielectric strength, high resistivity, and low dielectric loss in addition to good chemical and mechanical properties. In this work, various polymer compounds were prepared, consisting of low-density polyethylene (LDPE), high-density polyethylene (HDPE), polypropylene (PP), HDPE/PP, and LDPE/PP polymer blends. The relative permittivity and breakdown strength of each sample types were evaluated. In order to determine the physical properties of the prepared samples, the samples were also characterized using differential scanning calorimetry (DSC). The results showed that the dielectric constant of PP increased with the increase of HDPE and LDPE content. The breakdown measurement data for all samples were analyzed using the cumulative probability plot of Weibull distribution. From the acquired results, it was found that the dielectric strengths of LDPE and HDPE were higher than that of PP. Consequently, the addition of LDPE and HDPE to PP increased the breakdown strength of PP, but a variation in the weight ratio (30%, 50% and 70%) did not change significantly the breakdown strength. The DSC measurements showed two exothermic crystallization peaks representing two crystalline phases. In addition, the DSC results showed that the blended samples were physically bonded, and no co-crystallization occurred in the produced blends.

[1]  S. Ramaswami,et al.  Mechanical properties of PP-LDPE blends with novel morphologies produced with a continuous chaotic advection blender , 2005 .

[2]  Hazlee Azil Illias,et al.  Influence of Conductive and Semi-Conductive Nanoparticles on the Dielectric Response of Natural Ester-Based Nanofluid Insulation , 2018 .

[3]  P. Vassiliou,et al.  Temperature dependent dielectric spectroscopy in frequency domain of high-voltage transformer oils compared to physicochemical results , 2005, IEEE Transactions on Dielectrics and Electrical Insulation.

[4]  W. Yuan,et al.  Effect of phase compatibility on the foaming behavior of LDPE/HDPE and LDPE/PP blends with subcritical CO2 as the blowing agent , 2017 .

[5]  Ruijin Liao,et al.  Grey Relational Analysis for Insulation Condition Assessment of Power Transformers Based Upon Conventional Dielectric Response Measurement , 2017 .

[6]  Peter H. Fischer,et al.  The Short-Time Electric Breakdown Behavior of Polyethylene , 1974, IEEE Transactions on Electrical Insulation.

[7]  Hao Wen,et al.  Study on the Thermal and Dielectric Properties of SrTiO 3 /Epoxy Nanocomposites , 2017 .

[8]  C. Chen,et al.  Phase morphology and physical properties of PP/HDPE/organoclay (nano) composites with and without a maleated EPDM as a compatibilizer , 2010 .

[9]  S. Singha,et al.  Permittivity and tan delta characteristics of epoxy nanocomposites in the frequency range of 1 MHz-1 GHz , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[10]  Sylvie Bertin,et al.  Study and characterization of virgin and recycled LDPE/PP blends , 2002 .

[11]  S. Gubanski,et al.  Highly Efficient Interfaces in Nanocomposites Based on Polyethylene and ZnO Nano/Hierarchical Particles: A Novel Approach toward Ultralow Electrical Conductivity Insulations , 2016, Advanced materials.

[12]  M. Zanin,et al.  Assessment of dielectric behavior of recycled/virgin high density polyethylene blends , 2004, IEEE Transactions on Dielectrics and Electrical Insulation.

[13]  A. Lappas,et al.  Chemical recycling of plastic wastes made from polyethylene (LDPE and HDPE) and polypropylene (PP). , 2007, Journal of hazardous materials.

[14]  Alun S. Vaughan,et al.  Structure–property relationships in polyethylene blends: the effect of morphology on electrical breakdown strength , 1997 .

[15]  M. G. Mohamed,et al.  Electrical and mechanical properties of polyethylene–rubber blends , 1998 .

[16]  A. M. Pourrahimi,et al.  The Role of Interfaces in Polyethylene/Metal‐Oxide Nanocomposites for Ultrahigh‐Voltage Insulating Materials , 2018, Advanced materials.

[17]  Cheng-En Lee,et al.  Characterization of PP/HDPE blend-based nanocomposites using different maleated polyolefins as compatibilizers , 2010 .

[18]  A. Krivda,et al.  Dielectric properties of epoxy based nanocomposites for high voltage insulation , 2011, IEEE Transactions on Dielectrics and Electrical Insulation.

[19]  C. Albano,et al.  Effects of coupling agents on mechanical and morphological behavior of the PP/HDPE blend with two different CaCO3 , 2002 .

[20]  Masayuki Ieda,et al.  Dielectric Breakdown Process of Polymers , 1980, IEEE Transactions on Electrical Insulation.

[21]  U. Gedde,et al.  Aqueous Synthesis of (21̅0) Oxygen-Terminated Defect-Free Hierarchical ZnO Particles and Their Heat Treatment for Enhanced Reactivity. , 2016, Langmuir : the ACS journal of surfaces and colloids.

[22]  F. Medellín-Rodríguez,et al.  Compatibility mechanisms between EVA and complex impact heterophasic PP-EPx copolymers as a function of EP content , 2005 .

[23]  M. Narkis,et al.  On the percolative behavior of carbon black cross-linked polyethylene systems , 1987 .

[24]  A. Darus,et al.  Electrical tracking performance of LLDPE-natural rubber blends by employing combination of leakage current level and rate of carbon track propagation , 2005, IEEE Transactions on Dielectrics and Electrical Insulation.

[25]  Q. Fu,et al.  Shear‐Induced Morphological Change in PP/LLDPE Blend , 2002 .

[26]  L. Akcelrud,et al.  Correlations between composition and crystallinity of LDPE/HDPE blends , 2008 .

[27]  H. Ahmad,et al.  Ageing studies on transmission line glass insulators using dielectric dissipation factor test , 2010, 2010 Conference Proceedings IPEC.

[28]  A. S. Luyt,et al.  Comparative study of the morphology and properties of PP/LLDPE/wood powder and MAPP/LLDPE/wood powder polymer blend composites , 2010 .

[29]  U. Gedde,et al.  First-principle simulations of electronic structure in semicrystalline polyethylene , 2017, The Journal of chemical physics.

[30]  L. Schadler,et al.  Influence of nanoparticle surface modification on the electrical behaviour of polyethylene nanocomposites , 2005 .

[31]  A. Diaz,et al.  Three-Dimensional Nanometer Features of Direct Current Electrical Trees in Low-Density Polyethylene. , 2017, Nano letters.

[32]  Villgot Englund,et al.  Highly Insulating Polyethylene Blends for High-Voltage Direct-Current Power Cables. , 2017, ACS macro letters.

[33]  Zhe Xing,et al.  Preparation of radiation crosslinked foams from low‐density polyethylene/ethylene‐vinyl acetate (LDPE/EVA) copolymer blend with a supercritical carbon dioxide approach , 2013 .

[34]  B. Ang,et al.  Effect of surface discharges on different polymer dielectric materials under high field stress , 2017, IEEE Transactions on Dielectrics and Electrical Insulation.

[35]  Nicole R. Demarquette,et al.  Influence of coalescence and interfacial tension on the morphology of PP/HDPE compatibilized blends , 2002 .

[36]  Xiaoxing Zhang,et al.  Study on the Thermal and Dielectric Properties of SrTiO3/Epoxy Nanocomposites , 2017 .