论文信息 - Optimization of machining parameters in WEDM of Monel 400 using Taguchi technique - 字舞流文

Optimization of machining parameters in WEDM of Monel 400 using Taguchi technique

N. Arunkumar | M. Ganesh | Naren Vivekanandan

[1] K. Maity,et al. Experimental investigation on tool life and chip morphology in hot machining of Monel-400 , 2018, Engineering Science and Technology, an International Journal.

[2] N. Sharma,et al. WEDM of nickel based aerospace alloy: optimization of process parameters and modelling , 2017 .

[3] G. Samuel,et al. Modeling and analysis of crater formation during wire electrical discharge turning (WEDT) process , 2015 .

[4] N. Tosun,et al. The Effect of Cutting Parameters on Wire Crater Sizes in Wire EDM , 2003 .

[5] M. Sarcar,et al. Optimization of Wire Electric Discharge Machining Parameters for Surface Roughness on 316 L Stainless Steel Using Full Factorial Experimental Design , 2014 .

[6] M. Durairaj,et al. Analysis of Process Parameters in Wire EDM with Stainless Steel Using Single Objective Taguchi Method and Multi Objective Grey Relational Grade , 2013 .

[7] Bulan Abdullah,et al. Influence of machine feed rate in WEDM of Titanium Ti-6Al-4V with constant current (6A) using brass wire , 2012 .