A vapor chamber using extended condenser concept for ultra-high heat flux and large heater area

Abstract We proposed an extended vapor chamber (EVC), consisting of an evaporator part and an extended condenser part. A layer of compressed copper foam was sintered on the inner evaporator surface. The extended condenser includes a circular-straight groove network and a fin region. The groove network distributes generated vapor everywhere in the internal volume of EVC. A set of capillary holes are machined within fins. A sliced copper foam bar is inserted in each of capillary hole. The peaks of copper foam bar are tightly contacted with the evaporator copper foam piece. Water is used as the working fluid with a heater area of 0.785 cm2. A minimum thermal resistance of 0.03 K/W is reached for the bottom heating. The heat flux is up to 450 W/cm2 without reaching dryout. The transition point of thermal resistances versus heat fluxes is significantly delayed with the heat flux exceeding 300 W/cm2, beyond which thermal resistances are only slightly increased. EVC not only improves temperature uniformity on the evaporator and fin base surfaces, but also evens the temperature distribution along the fin height direction to increase the fin efficiency. Inclination angles and charge ratios are combined to affect the thermal performance of EVC. An optimal charge ratio of 0.3 was recommended. EVC can be used for ultra-high heat flux and larger heater area conditions.

[1]  L. Mok,et al.  A Graphite Foams Based Vapor Chamber for Chip Heat Spreading , 2006 .

[2]  Gisuk Hwang,et al.  Multi-artery heat-pipe spreader: Lateral liquid supply , 2011 .

[3]  Mehmet Arik,et al.  Thermal challenges in the future generation solid state lighting applications: light emitting diodes , 2002, ITherm 2002. Eighth Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (Cat. No.02CH37258).

[4]  Jinliang Xu,et al.  Copper foam based vapor chamber for high heat flux dissipation , 2012 .

[5]  Shwin-Chung Wong,et al.  A novel vapor chamber and its performance , 2010 .

[6]  Qiang Li,et al.  Investigation on transient behaviors of flat plate heat pipes , 2004 .

[7]  Y. Jaluria,et al.  Performance Characteristics of Vapor Chambers with Boiling Enhanced Multi-Wick Structures , 2007, Twenty-Third Annual IEEE Semiconductor Thermal Measurement and Management Symposium.

[8]  Hung-Yi Li,et al.  Thermal performance of plate-fin vapor chamber heat sinks☆ , 2010 .

[9]  Thermal Performance of a Vapor Chamber Heat Pipe with Diamond-Copper Composition Wick Structures , 2009, 2009 4th International Microsystems, Packaging, Assembly and Circuits Technology Conference.

[10]  Amir Faghri,et al.  Flat Miniature Heat Pipes With Micro Capillary Grooves , 1999 .

[11]  T. Nguyen,et al.  Micro Channel Vapor Chamber for high heat Spreading , 2008, Electronic Packaging Technology Conference.

[12]  Thang Nguyen,et al.  Low Profile-High Performance Vapor Chamber Heat Sinks For Cooling High-Density Blade Servers , 2007, Twenty-Third Annual IEEE Semiconductor Thermal Measurement and Management Symposium.

[13]  S. Ushioda,et al.  Fundamental investigation of roll bond heat pipe as heat spreader plate for notebook computers , 2000 .