Simulation of a Plate Heat Exchanger Operating with Nanofluid Coolant Using CFD

Received: 22 May 2020 Accepted: 14 December 2020 The use of nanofluids as coolant fluid in a plate heat exchanger (PHE) was investigated by conducting 3D CFD (Computational Fluid Dynamics) simulations. Al2O3/water nanofluid with volume concentrations of 2%, 3% and 4% was used as coolant fluid and water as hot fluid. In addition, the effects of corrugation angle of the plates were analyzed by varying them between 0° and 60°. Validation was performed by using heat transfer coefficients experimentally obtained in a previous study. Results show that the use of nanofluids in higher concentrations improves the performance of the PHE’s parameters. The angles of 30° and 60° between the plates reduce pressure drop and reflux regions improving the heat exchange. The variations of the nanofluid flow must take into account the proper pressure drop for the process where is PHE is employed because the increased flow rate results in a significant increase in the pressure drop. In general, this work has potential to be used for enhancing the design of PHEs.

[1]  P. Ghosh,et al.  Experimentation on effect of particle ratio on hydrothermal performance of plate heat exchanger using hybrid nanofluid , 2019, Applied Thermal Engineering.

[2]  H. Ali,et al.  Thermal conductivity of hybrid nanofluids: A critical review , 2018, International Journal of Heat and Mass Transfer.

[3]  M. Sarafraz,et al.  Heat transfer and fluid flow of MgO/ethylene glycol in a corrugated heat exchanger , 2018, Journal of Mechanical Science and Technology.

[4]  S. H. Pourhoseini,et al.  Effect of silver-water nanofluid on heat transfer performance of a plate heat exchanger: An experimental and theoretical study , 2018, Powder Technology.

[5]  R. Saidur,et al.  Heat transfer and pressure drop characteristics of a plate heat exchanger using water based Al2O3 nanofluid for 30° and 60° chevron angles , 2018, Heat and Mass Transfer.

[6]  Mehdi Bahiraei,et al.  Recent research contributions concerning use of nanofluids in heat exchangers: A critical review , 2018 .

[7]  Jahar Sarkar,et al.  Discrete phase numerical model and experimental study of hybrid nanofluid heat transfer and pressure drop in plate heat exchanger , 2018 .

[8]  Babita,et al.  Preparation and evaluation of stable nanofluids for heat transfer application: A review , 2016 .

[9]  I. A. Stogiannis,et al.  Efficacy of SiO2 nanofluids in a miniature plate heat exchanger with undulated surface , 2015 .

[10]  Jahar Sarkar,et al.  Numerical investigation of heat transfer and fluid flow in plate heat exchanger using nanofluids , 2014 .

[11]  M. Khoshvaght-Aliabadi,et al.  Effects of geometrical parameters on performance of plate-fin heat exchanger: Vortex-generator as core surface and nanofluid as working media , 2014 .

[12]  Jahar Sarkar,et al.  Heat transfer and pressure drop characteristics of CeO2/water nanofluid in plate heat exchanger , 2013 .

[13]  F. S. Javadi,et al.  The effects of nanofluid on thermophysical properties and heat transfer characteristics of a plate heat exchanger , 2013 .

[14]  V. K. Nema,et al.  Experimental analysis of heat transfer and friction factor of nanofluid as a coolant in a corrugated plate heat exchanger , 2012 .

[15]  N. Zhang,et al.  Design and optimization of plate heat exchanger networks , 2017 .