Wide bandwidth transimpedance amplifier for extremely high sensitivity continuous measurements.

This article presents a wide bandwidth transimpedance amplifier based on the series of an integrator and a differentiator stage, having an additional feedback loop to discharge the standing current from the device under test (DUT) to ensure an unlimited measuring time opportunity when compared to switched discharge configurations while maintaining a large signal amplification over the full bandwidth. The amplifier shows a flat response from 0.6 Hz to 1.4 MHz, the capability to operate with leakage currents from the DUT as high as tens of nanoamperes, and rail-to-rail dynamic range for sinusoidal current signals independent of the DUT leakage current. Also available is a monitor output of the stationary current to track experimental slow drifts. The circuit is ideal for noise spectral and impedance measurements of nanodevices and biomolecules when in the presence of a physiological medium and in all cases where high sensitivity current measurements are requested such as in scanning probe microscopy systems.

[1]  C.A.T. Salama,et al.  Differential pass-transistor logic , 1993, IEEE Circuits and Devices Magazine.

[2]  Bernabé Linares-Barranco,et al.  On the design and characterization of femtoampere current-mode circuits , 2003, IEEE J. Solid State Circuits.

[3]  T H Oosterkamp,et al.  The electron conduction of photosynthetic protein complexes embedded in a membrane , 2004, FEBS letters.

[4]  Ja-Yong Koo,et al.  A low-noise and wide-band ac boosting current-to-voltage amplifier for scanning tunneling microscopy , 2005 .

[5]  Robert G. Meyer,et al.  Analysis and Design of Analog Integrated Circuits , 1993 .

[6]  Arthur Gelb,et al.  Multiple-Input Describing Functions and Nonlinear System Design , 1968 .

[7]  E Artacho,et al.  Absence of dc-conductivity in lambda-DNA. , 2000, Physical review letters.

[8]  D. Branton,et al.  Microsecond time-scale discrimination among polycytidylic acid, polyadenylic acid, and polyuridylic acid as homopolymers or as segments within single RNA molecules. , 1999, Biophysical journal.

[9]  Stefan Howorka,et al.  Detecting protein analytes that modulate transmembrane movement of a polymer chain within a single protein pore , 2000, Nature Biotechnology.

[10]  Felice Crupi,et al.  How to enlarge the bandwidth without increasing the noise in OP-AMP-based transimpedance amplifier , 2006, IEEE Transactions on Instrumentation and Measurement.

[11]  R. R. Harrison,et al.  A low-power low-noise CMOS amplifier for neural recording applications , 2003, IEEE J. Solid State Circuits.

[12]  Paul O'Connor,et al.  CMOS preamplifier for low-capacitance detectors , 1997 .

[13]  Masayuki Fujita,et al.  Continuous wave lasing in GaInAsP microdisk injection laser with threshold current of 40 /spl mu/A , 2000 .

[14]  M. J. Rost,et al.  Scanning probe microscopes go video rate and beyond , 2005 .

[15]  Emiliano Pallecchi,et al.  Development of an ultralow current amplifier for scanning tunneling microscopy , 2004 .

[16]  Rashid Bashir,et al.  Direct current electrical characterization of ds-DNA in nanogap junctions , 2005 .

[17]  A. Demosthenous,et al.  A 230-nW 10-s time constant CMOS integrator for an adaptive nerve signal amplifier , 2004, IEEE Journal of Solid-State Circuits.

[18]  Veljko Radeka,et al.  Front-end electronics for imaging detectors , 2000 .

[19]  Marco Sampietro,et al.  Linear transconductor with rail-to-rail input swing for very large time constant applications , 2006 .

[20]  M Muthukumar,et al.  Simulations of stochastic sensing of proteins. , 2005, Journal of the American Chemical Society.