Statistical experimental design in plasma etch modeling

The objective of this work is to obtain a comprehensive set of empirical models for plasma etch rates, uniformity, selectivity, and anisotropy. These models accurately represent the behavior of a specific piece of equipment under a wide range of etch recipes, thus making them ideal for manufacturing and diagnostic purposes. The response characteristics of a CCl/sub 4/-based plasma process used to etch doped polysilicon were examined via a 2/sup 6-1/ fractional factorial experiment followed by a Box-Wilson design. The effects of variation in RF power, pressure, electrode spacing, CCl/sub 4/ flow, He flow and O/sub 2/ flow on several output variables, including etch rate, selectivity, and process uniformity, were investigated. Etch anisotropy was also measured by scanning electron microscopy analysis on a 2/sup 6-2/ fraction of the original experiment. The screening factorial experiment was designed to isolate the most significant input parameters. Using this information as a platform from which to proceed, the subsequent phase of the experiment allowed the development of empirical models of etch behavior using response surface methodology (G. E. P. Box and N. D. Draper, 1987). The models were subsequently used to optimize the etch process. >

[1]  R. R. Hocking.  The analysis and selection of variables in linear regression , 1976 .

[2]  M. J. D. Powell,et al.  A fast algorithm for nonlinearly constrained optimization calculations , 1978 .

[3]  D. Bower.  Planar Plasma Etching of Polysilicon Using CCl4 and NF 3 , 1982 .

[4]  C. Zarowin,et al.  Control of Plasma Etch Profiles with Plasma Sheath Electric Field and RF Power Density , 1982 .

[5]  Vincent M. Donnelly,et al.  Basic chemistry and mechanisms of plasma etching , 1983 .

[6]  P. E. Riley.  Development of a Highly Uniform Silicon Dioxide Etching Process Using Response‐Surface Methodology , 1986 .

[7]  H. Sawin,et al.  Polysilicon Etching in SF 6 RF Discharges Characteristics and Diagnostic Measurements , 1986 .

[8]  M. Elta,et al.  Large‐signal time‐domain modeling of low‐pressure rf glow discharges , 1987 .

[9]  Mark A. Wirzbicki,et al.  Characterization of etching of silicon dioxide and photoresist in a fluorocarbon plasma , 1988 .

[10]  Michael E. Elta,et al.  A Monte Carlo microtopography model for investigating plasma/reactive ion etch profile evolution , 1988 .

[11]  H. Sawin,et al.  n+‐Polysilicon Etching in CCl4 / He Discharges: Characterization and Modeling , 1989 .

[12]  D. Manos,et al.  Plasma etching : an introduction , 1989 .

[13]  Paul E. Riley,et al.  Development of a Multistep SiO2 Plasma Etching Process in a Minibatch Reactor Using Response‐Surface Methodology , 1989 .

[14]  P. E. Riley,et al.  Study of etch rate characteristics of SF/sub 6//He plasmas by response-surface methodology: effects of interelectrode spacing , 1989 .

[15]  S.W. Director,et al.  An efficient methodology for building macromodels of IC fabrication processes , 1989, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..