Sulfonated PEEK-WC membranes for possible fuel cell applications

Abstract Sulfonated polyetheretherketones are polymers of some interest for preparing membranes as alternative to the expensive perfluorinated membranes (e.g. Nafion) presently used for fuel cell applications. Sulfonated poly(oxa- p -phenylene-3,3-phtalido- p -phenylene-oxa- p -phenilene-oxy-phenylene) (PEEK-WC) with various degrees of substitution (DS) was prepared and then characterized by FT-IR analyses. Sulfonated PEEK-WC dense membranes were tested for their permeability to various gases and vapors. At 60 °C, the permeability coefficient of methanol in a sulfonated PEEK-WC membrane with 70% DS was about two orders of magnitude lower in comparison with that in a Nafion 117 membrane. Conductivity measurements were carried out by the impedance technique as a function of relative humidity (RH), at 100 °C, and as a function of temperature, in the range 50–115 °C, at 100% RH. The proton conductivity strongly increases with temperature and DS and reaches 2.5×10 −2  S cm −1 at 115 °C and 100% RH for DS=0.82. The hydration of the sulfonated polymer was also determined under the same conditions used for conductivity measurements.

[1]  G. Alberti.  Inorgano-organic proton conducting membranes for fuel cells and sensors at medium temperatures , 2000 .

[2]  Takeshi Kobayashi,et al.  Proton-conducting polymers derived from poly(ether-etherketone) and poly(4-phenoxybenzoyl-1,4-phenylene) , 1998 .

[3]  O. Savadogo.  Emerging Membranes for Electrochemical Systems: (I) Solid Polymer Electrolyte Membranes for Fuel Cell Systems , 1998 .

[4]  Kai Sundmacher,et al.  Current Status of and Recent Developments in the Direct Methanol Fuel Cell , 2001 .

[5]  B. Baradie,et al.  Hybrid Nafion®-inorganic membrane with potential applications for polymer electrolyte fuel cells , 2000 .

[6]  M. Pegoraro,et al.  Recast Nafion‐117 thin film from water solution , 2000 .

[7]  Enrico Drioli,et al.  Sulfonation of polyetheretherketone by chlorosulfuric acid , 1998 .

[8]  Deborah J. Jones,et al.  Non-Fluorinated Polymer Materials for Proton Exchange Membrane Fuel Cells , 2003 .

[9]  Deborah J. Jones,et al.  Recent advances in the functionalisation of polybenzimidazole and polyetherketone for fuel cell applications , 2001 .

[10]  Bernd Bauer,et al.  Polymeric proton conducting membranes for medium temperature fuel cells (110–160°C) , 2001 .

[11]  Michael D. Guiver,et al.  Proton conducting composite membranes from polyether ether ketone and heteropolyacids for fuel cell applications , 2000 .

[12]  F. Büchi,et al.  In-situ resistance measurements of Nafion® 117 membranes in polymer electrolyte fuel cells , 1996 .

[13]  J. Kerres.  Development of ionomer membranes for fuel cells , 2001 .

[14]  Robert F. Savinell,et al.  Real‐Time Mass Spectrometric Study of the Methanol Crossover in a Direct Methanol Fuel Cell , 1996 .

[15]  Detlef Stolten,et al.  Recent developments of the measurement of the methanol permeation in a direct methanol fuel cell , 2002 .

[16]  L. Carrette,et al.  Fuel Cells - Fundamentals and Applications , 2001 .

[17]  Xiaofeng Xu,et al.  Sulfonation of polyetheretherketone and its effects on permeation behavior to nitrogen and water vapor , 1996 .

[18]  Marcel Mulder,et al.  Basic Principles of Membrane Technology , 1991 .

[19]  K. Kreuer.  On the development of proton conducting polymer membranes for hydrogen and methanol fuel cells , 2001 .