A study of vortex-induced energy harvesting from water using PZT piezoelectric cantilever with cylindrical extension

Abstract The energy of water flow exists everywhere and it can drive the piezoelectric energy harvester to vibrate to generate electricity. This paper presents an upright vortex-induced piezoelectric energy harvester (VIPEH), inspired by the vortex-induced vibration (VIV) of cylinder in flowing fluid. This harvester consists of a PZT cantilever with a cylindrical extension. Energy harvesting ability of the VIPEH is investigated theoretically and experimentally. An Euler–Bernoulli distributed parameter model as the available electromechanical model for the energy harvester is established. The optimum load resistances R (100–150 kΩ) are obtained for various water velocities. The maximum output power is 84.49 μW with 60.35 mW/m 2 energy density at the resonance vibration velocity of 0.35m/s. The experimental results are in good agreement with the numerical results. Further, both influences of the cylinder diameter and mass on the energy harvesting ability are investigated. The results show that the VIPEH can achieve better energy harvesting performance from water flow with a lighter weight mass and a larger diameter of the attached cylinder.

[1]  Xiaotong Gao,et al.  Flow Energy Harvesting Using Piezoelectric Cantilevers With Cylindrical Extension , 2013, IEEE Transactions on Industrial Electronics.

[2]  Takaaki Ishii,et al.  Energy Flow Analysis in Piezoelectric Energy Harvesting Systems , 2010 .

[3]  S. Krylov,et al.  Pull-in Dynamics of an Elastic Beam Actuated by Continuously Distributed Electrostatic Force , 2004 .

[4]  Jayant Sirohi,et al.  Piezoelectric wind energy harvester for low-power sensors , 2011 .

[5]  Paul K. Wright,et al.  Vortex shedding induced energy harvesting from piezoelectric materials in heating, ventilation and air conditioning flows , 2012 .

[6]  Wei Wang,et al.  Vibration energy harvesting with a clamped piezoelectric circular diaphragm , 2012 .

[7]  Yaowen Yang,et al.  Vibration energy harvesting using macro-fiber composites , 2009 .

[8]  Deniz Tolga Akcabay,et al.  Scaling the dynamic response and energy harvesting potential of piezoelectric beams , 2012 .

[9]  J. C. Park,et al.  Asymmetric PZT bimorph cantilever for multi-dimensional ambient vibration harvesting , 2013 .

[10]  Joseph R. Burns,et al.  The Energy Harvesting Eel: a small subsurface ocean/river power generator , 2001 .

[11]  Daniel J. Inman,et al.  An experimentally validated bimorph cantilever model for piezoelectric energy harvesting from base excitations , 2009 .

[12]  Yiannis Andreopoulos,et al.  Interactions of vortices with a flexible beam with applications in fluidic energy harvesting , 2014 .

[13]  Ephrahim Garcia,et al.  Toward efficient aeroelastic energy harvesting: device performance comparisons and improvements through synchronized switching , 2013, Smart Structures.

[14]  Jayant Sirohi,et al.  Harvesting Wind Energy Using a Galloping Piezoelectric Beam , 2012 .

[15]  Deniz Tolga Akcabay,et al.  Hydroelastic response and energy harvesting potential of flexible piezoelectric beams in viscous flow , 2012 .

[16]  Abdessattar Abdelkefi,et al.  Piezoelectric energy harvesting from concurrent vortex-induced vibrations and base excitations , 2014 .

[17]  Muhammad R. Hajj,et al.  Performance analysis of galloping-based piezoaeroelastic energy harvesters with different cross-section geometries , 2014 .

[18]  Yaowen Yang,et al.  Comparison of modeling methods and parametric study for a piezoelectric wind energy harvester , 2013 .

[19]  C. Norberg.  Fluctuating lift on a circular cylinder: review and new measurements , 2003 .

[20]  Muhammad R. Hajj,et al.  Piezoelectric energy harvesting from vortex-induced vibrations of circular cylinder , 2013 .

[21]  A. Smits,et al.  Energy harvesting eel , 2001 .

[22]  Daniel J. Inman,et al.  A Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters , 2008 .