Applying image analysis techniques to tomographic images of irradiated nuclear fuel assemblies

Abstract In this paper we present a set of image analysis techniques used for extraction of information from cross-sectional images of nuclear fuel assemblies, achieved from gamma emission tomography measurements. These techniques are based on template matching, an established method for identifying objects with known properties in images. We demonstrate a rod template matching algorithm for identification and counting of the fuel rods present in the image. This technique may be applicable in nuclear safeguards inspections, because of the potential of verifying the presence of all fuel rods, or potentially discovering any that are missing. We also demonstrate the accurate determination of the position of a fuel assembly, or parts of the assembly, within the imaged area. Accurate knowledge of the assembly position enables detailed modelling of the gamma transport through the fuel, which in turn is needed to make tomographic reconstructions quantifying the activity in each fuel rod with high precision. Using the full gamma energy spectrum, details about the location of different gamma-emitting isotopes within the fuel assembly can be extracted. We also demonstrate the capability to determine the position of supporting parts of the nuclear fuel assembly through their attenuating effect on the gamma rays emitted from the fuel. Altogether this enhances the capabilities of non-destructive nuclear fuel characterization.

[1]  S. Holcombe,et al.  A Novel gamma emission tomography instrument for enhanced fuel characterization capabilities within the OECD Halden Reactor Project , 2015 .

[2]  Peter Andersson,et al.  Tomographic determination of spent fuel assembly pin-wise burnup and cooling time for detection of anomalies , 2015 .

[3]  Peter Jansson,et al.  A Device for Nondestructive Experimental Determination of the Power Distribution in a Nuclear Fuel Assembly , 2006 .

[4]  J. A. Howell,et al.  Analysis of integrated video and radiation data , 1995 .

[5]  Mats Troeng.  Positioning of Nuclear Fuel Assemblies by Means of Image Analysis on Tomographic Data , 2004 .

[6]  Peter Jansson,et al.  Studies of Nuclear Fuel by Means of Nuclear Spectroscopic Methods , 2002 .

[7]  S. Holcombe.  Gamma Spectroscopy and Gamma Emission Tomography for Fuel Performance Characterization of Irradiated Nuclear Fuel Assemblies , 2014 .

[8]  R. Chawla,et al.  Determination of within-rod caesium and europium isotopic distributions in high burnup fuel rods through computerised gamma-ray emission tomography , 2009 .

[10]  S. Holcombe,et al.  Applicability of a set of tomographic reconstruction algorithms for quantitative SPECT on irradiated nuclear fuel assemblies , 2015 .

[11]  Holly R. Trellue,et al.  Passive Tomography for Spent Fuel Verification: Analysis Framework and Instrument Design Study. Proceedings of 37th ESARDA Symposium on Safeguards and Nuclear Non-Proliferation, Manchester, UK, 19–21 May 2015. pp 949–960 , 2015 .

[12]  B. Sawicka,et al.  Density gradients in ceramic pellets measured by computed tomography , 1988 .

[13]  C. Niculae,et al.  A comparison of four tomographic methods for nuclear fuel pin analysis , 1995 .

[14]  Tapani Honkamaa,et al.  A Prototype for passive gamma emission tomography , 2014 .

[15]  Tapani Honkamaa,et al.  CdTe linear arrays with integrated electronics for passive gamma emission tomography system , 2008, 2008 IEEE Nuclear Science Symposium Conference Record.

[16]  S. Caruso,et al.  Design, development and utilisation of a tomography station for γ-ray emission and transmission analyses of light water reactor spent fuel rods , 2014 .